A.required at the destination to implement Cisco IOS IP SLA services
B.improves measurement accuracy
C.required for VoIP jitter measurements
D.provides security on Cisco IOS IP SLA messages via LEAP or EAP-FAST authentication
E.responds to one Cisco IOS IP SLA operation per port
F.stores the resulting test statistics
您可能感興趣的試卷
你可能感興趣的試題
A.only implemented between Cisco source and destination-capable devices
B.statistics provided by syslog, CLI, and SNMP
C.measures delay, jitter, packet loss, and voice quality
D.only monitors VoIP traffic flows
E.provides active monitoring
F.provides passive monitoring
A.Test major changes before deployment and defer minor changes until during deployment.
B.Document and verify rollback procedures.
C.Ensure consistency of code versions across the network.
D.Progressively modify procedures and documentation during implementation.
A.work staff attributes, such as skills and communication
B.redundancy, to prevent single points of failure
C.processes, such as documentation, change control, and labs
D.appropriate technology, such as hardware and software
E.tools, such as those for monitoring and reporting
A.pleting aggressive implementation schedule
B.Stateful Switchover
C.pany and user expectations
D.Nonstop Forwarding
E.change control processes
F.dual devices and dual links
A.jitter
B.delay
C.PoE
D.bandwidth
E.packet loss
During voice implementation,
which two required items are configured at an access layer switch connected to an IP phone to provide VoIP communication?()
A.allowed codecs
B.native VLAN
C.auxiliary VLAN
D.Cisco Unified Communications Manager IP address
E.RSTP
A network is deployed using best practices of the enterprise campus network model, including users with desktop computers connected via IP phones. Given that all components are QoS-capable,
where are the two optimal locations for trust boundaries to be configured by the network administrator?()
A.host
B.IP phone
C.access layer switch
D.distribution layer switch
E.core layer switch
Wireless has been operating correctly in the campus infrastructure. After the wireless controllers are upgraded from LWAPP to CAPWAP, access points no longer boot and operate normally.
What is the most likely issue causing this problem?()
A.VLAN assignments
B.DHCP option 43
C.PoE
D.ACL
E.QoS
A standalone wireless AP solution is being installed into the campus infrastructure. The access points appear to boot correctly, however, wireless clients are not obtaining correct access. You verify that the local switch configuration connected to the access point appears as the following:
interface ethernet 0/1
switchport access vlan 10
switchport mode access
spanning-tree portfast
mls qos trust dscp
What is the most likely issue causing the problem?()
A.QoS trust should not be configured on a port attached to a standalone AP.
B.QoS trust for switchport mode access should be defined as "cos".
C.switchport mode should be defined as "trunk" with respective QoS.
D.switchport access vlan should be defined as "1".
A campus infrastructure supports wireless clients via Cisco Aironet AG Series 1230, 1240, and 1250 access points. With DNS and DHCP configured, the 1230 and 1240 access points appear to boot and operate normally; however, the 1250 access points do not seem to operate correctly.
What is the most likely issue causing this problem?()
A.PoE
B.DHCP with option 150
C.DHCP with option 43
D.DNS
E.switch port does not support gigabit speeds
最新試題
Which statement is correct about RSTP port roles?()
Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct, what will be true about Switch 15?()
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this?()
Refer to the exhibit. For what purpose is the command show ip cef used?()
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result?()
If G1/0/1 on DS1 is shutdown, what will be the current priority value of the Vlan105’s group on DS1 ?()
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?()
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port:00:06:34: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/5 (not half duplex), with SW_A FastEthernet0/4 (half duplex) , with TBA05071417(Cat6K-B) 0/4 (half duplex). What would be the possible outcome of the problem?()
Which three statements about STP timers are true?()
Based on the show spanning-tree vlan 200 output shown in the exhibit, which two statements about the STP process for VLAN 200 are true? ()