You are tasked with designing a security solution for your network.
What information should be gathered prior to designing the solution?()
A.IP addressing design plans so that the network can be appropriately segmented to mitigate potential network threats
B.detailed security device specifications
C.results from pilot network testing
D.results from a network audit
您可能感興趣的試卷
你可能感興趣的試題
You are tasked with designing a security solution for your network.
What information should be gathered prior to designing the solution?()
A.IP addressing design plans so that the network can be appropriately segmented to mitigate potential network threats
B.a list of the customer requirements
C.detailed security device specifications
D.results from pilot network testing
Cat6500(config)# router ospf 1
Cat6500(config-router)# network 0.0.0.0 255.255.255.255 area 0
Cat6500(config-router)# nsf Cat6500(config-router)#end
Refer to the exhibit. The configuration is used to enable nonstop forwarding for OSPF on a Catalyst 6500 Series
Switch with redundant supervisor engines.
The default CEF configuration is unchanged. After testing, user traffic is interrupted and NSF is not operational.
What is the most likely reason? ()
A.CEF was not properly configured.
B.OSPF was not properly configured for graceful restart.
C.Stateful switchover was not correctly configured.
D.NSF for OSPF is only supported in area 0.
To initiate testing,
which port does a Cisco IOS IP SLA source use to send a control message to an IP SLA responder? ()
A.UDP port 2020
B.UDP port 1967
C.TCP port 2020
D.ICMP port 1967
A.required at the destination to implement Cisco IOS IP SLA services
B.improves measurement accuracy
C.required for VoIP jitter measurements
D.provides security on Cisco IOS IP SLA messages via LEAP or EAP-FAST authentication
E.responds to one Cisco IOS IP SLA operation per port
F.stores the resulting test statistics
A.only implemented between Cisco source and destination-capable devices
B.statistics provided by syslog, CLI, and SNMP
C.measures delay, jitter, packet loss, and voice quality
D.only monitors VoIP traffic flows
E.provides active monitoring
F.provides passive monitoring
A.Test major changes before deployment and defer minor changes until during deployment.
B.Document and verify rollback procedures.
C.Ensure consistency of code versions across the network.
D.Progressively modify procedures and documentation during implementation.
A.work staff attributes, such as skills and communication
B.redundancy, to prevent single points of failure
C.processes, such as documentation, change control, and labs
D.appropriate technology, such as hardware and software
E.tools, such as those for monitoring and reporting
A.pleting aggressive implementation schedule
B.Stateful Switchover
C.pany and user expectations
D.Nonstop Forwarding
E.change control processes
F.dual devices and dual links
A.jitter
B.delay
C.PoE
D.bandwidth
E.packet loss
During voice implementation,
which two required items are configured at an access layer switch connected to an IP phone to provide VoIP communication?()
A.allowed codecs
B.native VLAN
C.auxiliary VLAN
D.Cisco Unified Communications Manager IP address
E.RSTP
最新試題
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2?()
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port:00:06:34: %CDP-4-DUPLEX_MISMATCH: duplex mismatch discovered on FastEthernet0/5 (not half duplex), with SW_A FastEthernet0/4 (half duplex) , with TBA05071417(Cat6K-B) 0/4 (half duplex). What would be the possible outcome of the problem?()
Which router redundancy protocol cannot be configured for interface tracking?()
Refer to the exhibit. Initially, LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link?()
Refer to the exhibit. Which Virtual Router Redundancy Protocol (VRRP) statement is true about the roles of the master virtual router and the backup virtual router?()
Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct, what will be true about Switch 15?()
Which option correctly identifies the Cisco IOS switching methods in descending order from the fastest method to the slowest method?()
Which statement is correct about the use of the virtual interface on a WLC ?()
Which two statements about the various implementations of STP are true?()
Refer to the exhibit. For what purpose is the command show ip cef used?()