單項選擇題Which of the following commands would successfully implement an access list on a routers virtual terminal line?（）

A. RouterTK(config-line)# access-class 10 in
B. RouterTK(config-if)# ip access-class 23 out
C. RouterTK(config-line)# access-list 150 in
D. RouterTK(config-if)# ip access-list 128 out
E. RouterTK(config-line)# access-group 15 out
F. RouterTK(config-if)# ip access-group 110 in


您可能感興趣的試卷

你可能感興趣的試題

2.單項選擇題

The following access list below was applied outbound on the E0 interface connected to the 192.169.1.8/29 LAN:How will the above access lists affect traffic?（）

A. FTP traffic from 192.169.1.22 will be denied.
B. No traffic, except for FTP traffic will be allowed to exit E0.
C. FTP traffic from 192.169.1.9 to any host will be denied.
D. All traffic exiting E0 will be denied.
E. All FTP traffic to network 192.169.1.9/29 will be denied.

4.單項選擇題Which of the following statements regarding the use of multiple access lists are valid when configuring a single interface on a Cisco router?（）

A. Application of up to three access lists per protocol to a single interface.
B. No more than two access lists per interface.
C. One access list may be configured per direction for each Layer 3 protocol configured on an interface.
D. The maximum number allowed varies due to RAM availability in the router.
E. An infinite number of access lists that can be applied to an interface, from most specific to most general.
F. Cisco IOS allows only one access list to an interface.

5.多項選擇題

You're the systems administrator at Testing, and you create the following access control lists.
You then enter the command "ip access-group 101 in" to apply access control list 101 to router TK1s e0 interface.Which of the following Telnet sessions will be blocked as a result of your access lists?（）

A. Telnet sessions from host A to host 5.1.1.10
B. Telnet sessions from host A to host 5.1.3.10
C. Telnet sessions from host B to host 5.1.2.10
D. Telnet sessions from host B to host 5.1.3.8
E. Telnet sessions from host C to host 5.1.3.10
F. Telnet sessions from host F to host 5.1.1.10

6.單項選擇題You are securing a network for TestKing and want to apply an ACL (access control list) to an interface of a router. Which one of the following commands would you use?（）

A. permit access-list 101 out
B. ip access-group 101 out
C. apply access-list 101 out
D. access-class 101 out
E. ip access-list e0 out

7.單項選擇題What is the purpose of assigning an IP address to a switch?（）

A. Provides local hosts with a default gateway address
B. Allows remote management of the switch.
C. Allows the switch to respond to ARP requests between two hosts
D. Ensures that hosts on the same LAN can communicate with each other.

8.單項選擇題As a TestKing trainee you are required to set the default gateway on a Cisco switch to the IP address of 192.168.1.115. Which IOS command should you use?（）

A. TestKSwitch(config)# ip route-default 192.168.1.115
B. TestKSwitch(config)# ip default-gateway 192.168.1.115
C. TestKSwitch(config)# ip route 192.168.1.115 0.0.0.0
D. TestKSwitch(config)# ip default-network 192.168.1.115

9.多項選擇題Which interface commands would you enter on a Catalyst 2900 switch, if your goal was to bring all VLAN traffic to another directly connected switch?（）

A. Switch(config-if)# vlan all
B. Switch(config-if)# switchport trunk encapsulation dot1q
C. Switch(config-if)# switchport access vlan all
D. Switch(config-if)# switchport mode trunk
E. Switch(config-if)# switchport access vlan 303