A.SMTP
B.DNS
C.FTP
D.Telnet
E.HTTP
F.POP3
您可能感興趣的試卷
你可能感興趣的試題
A. Application of up to three access lists per protocol to a single interface.
B. No more than two access lists per interface.
C. One access list may be configured per direction for each Layer 3 protocol configured on an interface.
D. The maximum number allowed varies due to RAM availability in the router.
E. An infinite number of access lists that can be applied to an interface, from most specific to most general.
F. Cisco IOS allows only one access list to an interface.
You're the systems administrator at Testing, and you create the following access control lists.
You then enter the command "ip access-group 101 in" to apply access control list 101 to router TK1s e0 interface.Which of the following Telnet sessions will be blocked as a result of your access lists?()
A. Telnet sessions from host A to host 5.1.1.10
B. Telnet sessions from host A to host 5.1.3.10
C. Telnet sessions from host B to host 5.1.2.10
D. Telnet sessions from host B to host 5.1.3.8
E. Telnet sessions from host C to host 5.1.3.10
F. Telnet sessions from host F to host 5.1.1.10
A. permit access-list 101 out
B. ip access-group 101 out
C. apply access-list 101 out
D. access-class 101 out
E. ip access-list e0 out
A. Provides local hosts with a default gateway address
B. Allows remote management of the switch.
C. Allows the switch to respond to ARP requests between two hosts
D. Ensures that hosts on the same LAN can communicate with each other.
A. TestKSwitch(config)# ip route-default 192.168.1.115
B. TestKSwitch(config)# ip default-gateway 192.168.1.115
C. TestKSwitch(config)# ip route 192.168.1.115 0.0.0.0
D. TestKSwitch(config)# ip default-network 192.168.1.115
A. Switch(config-if)# vlan all
B. Switch(config-if)# switchport trunk encapsulation dot1q
C. Switch(config-if)# switchport access vlan all
D. Switch(config-if)# switchport mode trunk
E. Switch(config-if)# switchport access vlan 303
A. Configuration register
B. NVRAM
C. Boot flash
D. CMOS
E. Flash
A. Perform POST, locate configuration statements, apply configuration statements, locate Cisco IOS software, and load Cisco IOS software.
B. Locate Cisco IOS software, load Cisco IOS software, locate configuration statements, apply configuration statements, and perform POST.
C. Test software routines, POST, load configuration files, load Cisco IOS software, test Cisco IOS software.
D.POST, locate Cisco IOS software, load the Cisco IOS software, locate configuration statements, and apply configuration statements.
E. Load and test IOS, load configuration files, test software routines, POST.
You are unable to connect to the TESTKING1 router. Which of the following command sequences will correct this problem?()
A.
B.
C.
D.
E.
F.
You want the text "Unauthorized access prohibited!" to be displayed before the login prompt every time someone tries to initiate a Telnet session to a router, as shown in the example below:
Which command can be used to configure this message?()
A. login banner x Unauthorized access prohibited! X
B. banner exec y Unauthorized access prohibited! Y
C. banner motd x Unauthorized access prohibited! X
D. vtv motd "Unauthorized access prohibited!"
最新試題
What feature of a networks switch allows an administrative to create separate broadcast domains?()
What is the purpose of pressing the Ctrl+Break keys during the router password recover procedure?()
Which connections allow the use of full-duplex Ethernet?()
Identify three valid host addresses in the 192.168.27.0 network with a subnet mask of 255.255.255.240. ()
You are configuring a new Catalyst switch that you want to manage remotely from workstations on other network segments within your enterprise.Which of the following are required to allow remote management of the switch over IP?()
A Class C network address has been subnetted with a /27 mask.Which of the following addresses is a broadcast address for one of the resulting subnets?()
The following access list was applied outbound on he E0 interface connected to the 192.168.1.8/29 LAN:access-list 123 deny tcp 192.168.1.8 0.0.0.7 eq 20 anyaccess-list 123 deny tcp 192.168.1.9 0.0.0.7 eq 21 anyWhat effect will this access list have?()
Which of the following host addresses are member of networks that can be routed across the public Internet? ()
Which of the following if addresses can be assigned to host devices?()
A technician at TestKing needs to update the network documentation. One of the tasks includes documenting the name of the IOS image file of each router in the network.Which commands could be used to find this information?()