單項選擇題What is the purpose of assigning an IP address to a switch?()

A. Provides local hosts with a default gateway address
B. Allows remote management of the switch.
C. Allows the switch to respond to ARP requests between two hosts
D. Ensures that hosts on the same LAN can communicate with each other.


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題As a TestKing trainee you are required to set the default gateway on a Cisco switch to the IP address of 192.168.1.115. Which IOS command should you use?()

A. TestKSwitch(config)# ip route-default 192.168.1.115
B. TestKSwitch(config)# ip default-gateway 192.168.1.115
C. TestKSwitch(config)# ip route 192.168.1.115 0.0.0.0
D. TestKSwitch(config)# ip default-network 192.168.1.115

2.多項選擇題Which interface commands would you enter on a Catalyst 2900 switch, if your goal was to bring all VLAN traffic to another directly connected switch?()

A. Switch(config-if)# vlan all
B. Switch(config-if)# switchport trunk encapsulation dot1q
C. Switch(config-if)# switchport access vlan all
D. Switch(config-if)# switchport mode trunk
E. Switch(config-if)# switchport access vlan 303

4.單項選擇題After making some network changes you power off and then power on your Cisco router. What sequence of events occurs when a router is powered up?()

A. Perform POST, locate configuration statements, apply configuration statements, locate Cisco IOS software, and load Cisco IOS software.
B. Locate Cisco IOS software, load Cisco IOS software, locate configuration statements, apply configuration statements, and perform POST.
C. Test software routines, POST, load configuration files, load Cisco IOS software, test Cisco IOS software.
D.POST, locate Cisco IOS software, load the Cisco IOS software, locate configuration statements, and apply configuration statements.
E. Load and test IOS, load configuration files, test software routines, POST.

6.單項選擇題

You want the text "Unauthorized access prohibited!" to be displayed before the login prompt every time someone tries to initiate a Telnet session to a router, as shown in the example below:

Which command can be used to configure this message?()

A. login banner x Unauthorized access prohibited! X
B. banner exec y Unauthorized access prohibited! Y
C. banner motd x Unauthorized access prohibited! X
D. vtv motd "Unauthorized access prohibited!"

7.多項選擇題

The TestKingA router is configured as shown below:
TestKingA(config)# interface loopback 0
TestKingA(config-if)# ip address 192.168.16.24 255.255.255.255
As a result of this change, which of the statements below are true?()

A. It creates a virtual, software only, interface.
B. It provides a way to test the convergence of OSPF routing updates.
C. The mask of 255.255.255.255 is called a host mask.
D. It uses a wildcard mask of 255.255.255.255.
E. It ensures that an interface is always active for OSPF processes.
F. Loopback interfaces must be numbered 0.

9.多項選擇題What should be done prior to backing up an IOS image to a TFTP server?()

A. Make sure that the server can be reached across the network.
B. Check the authentication for TFTP access to the server is set.
C. Assure that the network server as adequate space for the IOS image.
D. Verify file naming and path requirements.
E. Make sure that the server can store binary files.
F. Adjust the TCP window size to speed up the transfer.

10.單項選擇題

A Cisco router has been configured, and the copy running-config startup-config command has been issued. When the router is power cycled, the router prompts with:
"Would you like to enter the initial configuration dialog? [yes/no]"
Why has this occurred?()

A. There is an error in the router DRAM.
B. Te IOS image is corrupt.
C. The configuration register is set to 0x2142.
D. The TFTP server that contains the router configuration file is unreachable.
E. A boot system configuration command has placed the router into setup mode.

最新試題

Which connections allow the use of full-duplex Ethernet?()

題型:多項選擇題

Identify three valid host addresses in the 192.168.27.0 network with a subnet mask of 255.255.255.240. ()

題型:多項選擇題

What is the purpose of pressing the Ctrl+Break keys during the router password recover procedure?()

題型:單項選擇題

A technician at TestKing needs to update the network documentation. One of the tasks includes documenting the name of the IOS image file of each router in the network.Which commands could be used to find this information?()

題型:單項選擇題

A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?()

題型:多項選擇題

What does a configuration Register Setting of 0x2105 indicate to the Router? ()

題型:單項選擇題

Given a subnet mask of 255.255.255.224, which of the following addresses can be assigned to network hosts?()

題型:多項選擇題

Which command is used to display the placement and direction of an IP access control list on a router?()

題型:單項選擇題

What is the subnetwork address for a host with IP address 201.100.5.68/28?()

題型:單項選擇題

A router with a serial interface will be used for an ISDN link.What other function group devices are required to complete the connection to the service provider? ()

題型:多項選擇題