A. 1
B. 64
C. 1562
D. 64000
E. 1500
您可能感興趣的試卷
你可能感興趣的試題
A. The exchange of advertisement is triggered by a change in the network.
B. All routers exchange routing tables with each other iIn a multipoint network.
C. Packets are routed based upon the shortest path to the destination.
D. Paths are chosen depending on the cost efficiency factor.
E. Every router in an OSPF area is capable of representing the entire network topology.
F. Only the designated router in an OSPF area can represent the entire network topology.
A. Distance vector protocols send the entire routing table to directly connected neighbors.
B. Distance vector protocols are responsible for sending updates to all networks listed in the routing table.
C. Link state protocols are responsible for sending the entire routing table to the whole network.
D. Link state protocols send updates regarding their own links status to all other routers on the network.
A. The IP address of the first Fast Ethernet interface.
B. The IP address of the console management interface.
C. The highest IP address among its active interfaces.
D. The lowest IP address among its active interfaces.
E. There will be no router ID until a loopback interface is configured.
A. Point-to-point
B. Broadcast multicast
C. Nonbroadcast multicast
D. Backbone area 0
E. Virtual Link
A. The RIP route
B. The static route
C. The IGRP route
D. All three will load balance.
A. 15
B. 16
C. 99
D. 255
E. Unlimited
A. Neighbor Table
B. SRF Table
C. RTP Table
D. Topology Table
E. Query Table
F. Dual Table
A. Only routers can split boundaries (horizons) between networks in separate AS numbers.
B. Each AS must keep routing tables converged to prevent dead routes from being advertised across boundaries.
C. Once a route is received on an interface, advertise that route as unreachable back out the same interface.
D. Information about a route should never be sent back in the direction from which the original update came.
A. IGRP
B. CDP
C. OSPF
D. RIP v1
E. RIP v2
F. EIGRP
A. Router(config-router)# network 192.168.10.0 0.0.0.255 0
B. Router(config-router)# network 192.168.10.0 0.0.0.255 area 0
C. Router(config-router)# network 192.168.10.0 255.255.255.0 area 0
D. Router(config)# router ospf 0
E. Router(config)# router ospf 1
最新試題
Which command is used to display the placement and direction of an IP access control list on a router?()
Which of the following options lists the steps in PPP session establishment in the correct order?()
A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? ()
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? ()
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? ()
Which connections allow the use of full-duplex Ethernet?()
Which of the following if addresses can be assigned to host devices?()
Given a subnet mask of 255.255.255.224, which of the following addresses can be assigned to network hosts?()
A Class C network address has been subnetted with a /27 mask.Which of the following addresses is a broadcast address for one of the resulting subnets?()
Which Frame Relay feature is responsible for transmitting keepalives to ensure that the PVC does not shut down because of inactivity?()