A. Data is accessed using NFS or CIFS.
B. Data is accessed at the block level.
C. NAS is referred to as captive storage.
D. Storage devices can be shared between users.
E. A NAS implementation is not as fast as a DAS implementation.
您可能感興趣的試卷
你可能感興趣的試題
A. The access layer is the first oversubscription point in a data center design.
B. When using a Layer 2 loop-free design, VLANs are extended into the aggregation layer.
C. When using a Layer 2 looped design, VLANs are not extended into the aggregation layer.
D. When using a Layer 3 design, stateful services requiring Layer 2 connectivity are provisionedfrom the aggregation layer.
E. The data center access layer provides the physical-level connections to the server resourcesand only operates at Layer 3.
A. Partitioning of network resources is enabled.
B. VRFs cannot support path isolation from MAN/WAN designs.
C. VRFs cannot be used to map a virtualized data center to a MPLS implementation.
D. VRFs do not allow for the use of application services with multiple access topologies.
E. An access design using a VRF allows for an aggregation layer service module solution.
A. Troubleshooting is more complicated.
B. Service and switch modules are underutilized.
C. Layer 2 adjacency is required with the servers that use this design.
D. Layer 3 adjacency is required with the servers that use this design.
E. Load balancing will always occur across both access layer uplinks.
A. Summarize data center subnets.
B. Use passive interfaces to ensure appropriate adjacencies.
C. Tune the EIGRP timers to enable EIGRP to achieve quicker convergence.
D. Adjust the default bandwidth value to ensure proper bandwidth on all links.
E. Advertise a default summary route into the data center core from the aggregation layer.
A. Never use passive interfaces.
B. Use NSSA areas from the core down.
C. Use totally stub areas to stop type 3 LSAs.
D. Use the lowest Ethernet interface IP address as the router ID.
E. Tune OSPF timers to enable OSPF to achieve quicker convergence
A. Server-to-server traffic always remains in the core layer.
B. The recommended practice is for the core infrastructure to be in Layer 3.
C. The boundary between Layer 2 and Layer 3 should be implemented in the aggregation layer.
D. The Cisco Express Forwarding hashing algorithm is the default, based on the IP address andLayer 4 port.
E. Core layer should run BGP along with an IGP because iBGP has a lower administrativedistance than any IGP.
A. ASM
B. BiDir PIM
C. PIM-SM RP
D. RP-Switchover
E. Source Specific Multicast
A. 0
B. 1
C. 2
D. 4
E. 16
F. infinity
Refer to the exhibit. Which two statements are correct regarding the creation of a multicas tdistribution tree? ()
A. Each router determines where to send the JOIN request.
B. The tree will be built based on the IP address of the E2 interface on router E
C. The best path to the source will be discovered in the unicast routing table on router B
D. The best path to the source will be discovered in the unicast routing table on router C
E. The best path to the source will be discovered in the unicast routing table on router E
A. a single host
B. a subset of hosts
C. all hosts sequentially
D. all hosts simultaneously
最新試題
Which two statements about Network Attached Storage are correct?()
The Cisco NAC Appliance is able to check which three items before allowing network access?()
Which signal and noise values will result in the best phone communication with an access point?()
Which two statements about Cisco Security Management Suite are correct? ()
What is the recommended radius of a cell for a voice-ready wireless network?()
Which two design recommendations are most appropriate when EIGRP is the data center corerouting protocol? ()
Which path selection protocol is used by Fibre Channel fabrics?()
Which two statements about FCIP and iSCSI are correct?()
Which statement about Fibre Channel communications is correct?()
Which three of the following descriptions are true about the firewall modes? ()