A. Troubleshooting is more complicated.
B. Service and switch modules are underutilized.
C. Layer 2 adjacency is required with the servers that use this design.
D. Layer 3 adjacency is required with the servers that use this design.
E. Load balancing will always occur across both access layer uplinks.
您可能感興趣的試卷
你可能感興趣的試題
A. Summarize data center subnets.
B. Use passive interfaces to ensure appropriate adjacencies.
C. Tune the EIGRP timers to enable EIGRP to achieve quicker convergence.
D. Adjust the default bandwidth value to ensure proper bandwidth on all links.
E. Advertise a default summary route into the data center core from the aggregation layer.
A. Never use passive interfaces.
B. Use NSSA areas from the core down.
C. Use totally stub areas to stop type 3 LSAs.
D. Use the lowest Ethernet interface IP address as the router ID.
E. Tune OSPF timers to enable OSPF to achieve quicker convergence
A. Server-to-server traffic always remains in the core layer.
B. The recommended practice is for the core infrastructure to be in Layer 3.
C. The boundary between Layer 2 and Layer 3 should be implemented in the aggregation layer.
D. The Cisco Express Forwarding hashing algorithm is the default， based on the IP address andLayer 4 port.
E. Core layer should run BGP along with an IGP because iBGP has a lower administrativedistance than any IGP.
A. ASM
B. BiDir PIM
C. PIM-SM RP
D. RP-Switchover
E. Source Specific Multicast
A. 0
B. 1
C. 2
D. 4
E. 16
F. infinity
Refer to the exhibit. Which two statements are correct regarding the creation of a multicas tdistribution tree？ （）
A. Each router determines where to send the JOIN request.
B. The tree will be built based on the IP address of the E2 interface on router E
C. The best path to the source will be discovered in the unicast routing table on router B
D. The best path to the source will be discovered in the unicast routing table on router C
E. The best path to the source will be discovered in the unicast routing table on router E
A. a single host
B. a subset of hosts
C. all hosts sequentially
D. all hosts simultaneously
A. TCP 502
B. TCP 514
C. TCP 520
D. UDP 502
E. UDP 514
F. UDP 520
A. supports multiple MIBs
B. includes NetFlow， NBAR， and IP SLA software subsystems
C. includes NetFlow， syslog， and IP SLA software subsystems
D. includes a predefined framework for filtering and correlating messages
E. supports two logging processes so output can be sent in standard and ESM format
A. DTP
B. RPR
C. SDH
D. CWDM
E. DWDM
最新試題
How many channels are defined in the IEEE 802.11b DSSS channel set？（）
Which three mechanisms are used to secure management traffic from outside IPS sensors？（）
One of your customers has deployed a Layer 3 gateway in the untrusted network. Which gateway mode is appropriate for this customer？（）
What is the traditional mode for a firewall？（）
In a collapsed core design， which two benefits are provided by a second-generation Cisco MDS director？ （）
Which two design recommendations are most appropriate when EIGRP is the data center corerouting protocol？ （）
Which two design recommendations are most appropriate when OSPF is the data center core routing protocol？ （）
Which three of the following descriptions are true about the firewall modes？ （）
Which two statements about Cisco Security Management Suite are correct？ （）
Which two statements about zoning are correct？（）