A. anycast frames
B. multicast frames
C. broadcast frames
D. unicast frames
您可能感興趣的試卷
你可能感興趣的試題
A. OSPF and mumber of hops and reliability
B. EIGRP and link cost
C. IS-IS and delay and reliability
D. RIPv2 and number of hops
A. dual stack
B. dynamic
C. Teredo
D. Manual 6to4
A. show running-config
B. show processes cpu
C. debug all
D. logging host ip address
A. Router(config)#password-encryption
B. Router(config)#service password-encryption
C. Router#service password-encryption
D. Router# password-encryption
A. IETF
B. HDLC
C. Q9333-A Annex A
D. ANSI Annex D
A. 120
B. 100
C. 90
D. 110
A. FF02::A
B. FF05::101
C. FF02::9
D. FF02::6
A. Automatic summarization at classful boundries can cause problems on discontinuous subnets
B. EIGRP and OSPF are classful routing protocols and summarize routes by default
C. RIPv1 and OSPF are classless routing protocols
D. Classful routing protocols send the subnet mask in routing updates
A. Cisco IOS IPsec/SSL VPN client
B. Cisco VPN Clinet
C. ISDN terminal adapter
D. Cisco Adaptive Security Appliance
A. data link
B. network
C. physical
D. transport
最新試題
What is the subnetwork address for a host with the IP address 201.100.5.68/28?()
What is the default administrative distance of OSPF?()
Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()
Which address is the IPV6 all-RIP-routers muticast group address that is used by RIPng as the destaion address?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()
How are VTP advertisements delivered to switches across the network?()
What is the purpose of the cisco Vlan Trunking protocol?()
Which command encrypts all plaintext passwords?()
Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()