Following ticket consists of a problem description and existing configuration on the device.
Figure 1
Cisco 642-832: Practice Exam
Figure 2
Trouble Ticket Statement
HSRP has been configurationured between DSW1 and DSW2. DSW1 is configurationured to be activerouter but it never becomes active even though the HSRP communication between DSW1 and DSW2 isworking.
Configuration on DSW1
CertKiller.com
track 1 ip route 10.1.21.128 255.255.0.0 metric threshold threshold metric up 1 down 2!
track 10 ip route 10.2.21.128 255.255.255.0 metric threshold threshold metric up 63 down 64!
interface Vlan10
ip address 10.2.1.1 255.255.255.0
standby 10 ip 10.2.1.254
standby 10 priority 200
standby 10 preempt
standby 10 track 1 decrement 60
Configuration on R4
Cisco 642-832: Practice Exam
interface loopback0
ip address 10.2.21.128 255.255.255.0
Fault Condition is related to which technology?()
A.GLBP
B.HSRP
C.OSPF
D.Switch to Switch Connectivity
您可能感興趣的試卷
你可能感興趣的試題
Following ticket consists of a problem description and existing configuration on the device.
Figure 1
Cisco 642-832: Practice Exam
Figure 2
Trouble Ticket Statement:
Client 1 is able to ping 10.1.1.2 but not 10.1.1.1. Initial troubleshooting shows that R1 does not have anyOSPF neighbors or any OSPF routes
Configuration on R1:
router ospf 1
CertKiller.com
log-adjacency-changes
network 10.1.1.0 0.0.0.3 area 12
default-information originate always!
interfaceSerial0/0/0/0.12 point-to-point
ip address 10.1.1.1 255.255.255.252
ip nat inside
ip ospf message-digest-key 1 md5 TSHOOT
Configuration on R2:
router ospf 1
log-adjacency-changes
network 10.1.1.0 0.0.0.3 area 12!
Cisco 642-832: Practice Exam
interfaceSerial0/0/0/0.12 point-to-point
ip address 10.1.1.2 255.255.255.252
ip ospf authentication message-digest
ip ospf message-digest-key 1 md5 TSHOOT
What is the solution of the fault condition?()
A.ipospf authentication message-digestcommand has to be added on S0/0/0/0.12
B.ipospf authentication message-digestcommand has to be added under the OSPF routing process
C.A static route to 10.1.1.4 must be added on R1
D.ipnat outside must be added on S0/0/0/0.12
A.Physical
B.Session
C.Application
D.Data-Link
E.Network
The following command is issued on a Cisco Router:
Router(configuration)#logging console warnings
Which alerts will be seen on the console?()
A.Warnings only
B.debugging, informational, notifications, warnings
C.warnings, errors, critical, alerts, emergencies
D.notifications, warnings, errors
E.warnings, errors, critical, alerts
A.ntp server 10.1.1.1 ntp server 10.1.1.2
B.ntp server 10.1.1.1 ntp server 10.1.1.2 primary
C.ntp server 10.1.1.1 ntp server 10.1.1.2 prefer
D.ntp server 10.1.1.1 fallback ntp server 10.1.1.2
What level of logging is enabled on a Router where the following logs are seen?()
A.alerts
B.critical
C.errors
D.notifications
The following commands are issued on a Cisco Router:
What will the debug output on the console show?()
A.All IP packets passing through the router
B.Only IP packets with the source address of 10.1.1.1
C.All IP packets from 10.1.1.1 to 172.16.1.1
D.All IP Packets between 10.1.1.1 and 172.16.1.1
最新試題
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
IPSec VPN is a widely-acknowledged solution for enterprise network. Which three IPsec VPNstatements are true?()
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec, which two parameters are required when defining the tunnel interfaceinformation?()
Which statement correctly describes IPsec VPN backup technology?()
Refer to the exhibit. Which two statements about the AAA configuration are true?()
Network Topology Exhibit:Configuration Exhibit:NET(config)# access-list 112 deny icmp any any echo logNET(config)# access-list 112 deny imp any any redirect logNET(config)# access-list 112 deny icmp any any mask-request logNET(config)# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET(config)# interface Fa0/1NET(config-if)# ip access-group 112 inYou work as a network administrator at networkTut.com, study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However, the configurationis incorrect. On the basis of the information in the exhibit, which configuration option wouldcorrectly configure router NET?()
Study the exhibit carefully. The Cisco IOS IPsec High Availability (IPsec HA) Enhancementsfeature provides an infrastructure for reliable and secure networks to provide transparent availability of the VPN gateways - that is, Cisco IOS Software-based routers. What are the twooptions that are used to provide High Availability IPsec?()
Drag the IPsec protocol description from the above to the correct protocol type on the below.(Notall descriptions will be used)Drag and Drop question, drag each item to its proper location.
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.(Not all options will be used)