A.Allows the transportation of all forms of traffic
B.Multiplexing is easy
C.Clocks do not need to be synchronized
D.Reduces network complexity and cost
E.Padding is not necessary and not permitted
您可能感興趣的試卷
你可能感興趣的試題
A.It is mainly used in Intra-AS MPLS VPLS deployments and is configured at the ASBR to avoid misconfiguration of the Route Target assignment for VPN configurations
B.It is mainly used in Inter-AS MPLS VPN deployments and is configured at the ASBR to avoid misconfiguration of the Route Target assignment for VPN configurations
C.It is mainly used in Intra-AS MPLS VPLS deployments and is configured at the Router Reflectorto avoid misconfiguration in Route Target assignment for VPN configurations
D.It is mainly used in Inter-AS MPLS VPLS deployments and is configured at the Router Reflectorto avoid misconfiguration of the Route Target assignment for VPN configurations
E.It is mainly used in Inter-AS MPLS VPLS deployments and is configured at the PE router to avoid to misconfiguration of the Route Target assignment for VPN configurations
A.Routing information received through an IBGP session is not forwarded to another IBGP neighbor， onlyto EBGP neighbors
B.Routing information received through an EBGP session is not forwarded to another EBGP neighbor，only to IBGP neighbors
C.BGP neighbor peerings are established and sychronized using the TCP 3-way handshake
D.BGP shall not advertise a route until that route has been learned via an IGP also
A.10 Gigabit Ethernet does not support VLAN definition
B.10 Gigabit Ethernet supports full duplex links， but does not support half duplex links
C.10 Gigabit Ethernet supports unshielded or shielded twisted-pair cable connections
D.10 Gigabit Ethernet supports Carrier Sense Multiple Access with Collision Detection （CSMA/CD）
E.10 Gigabit Ethernet supports optical fiber connections in single mode only. Mufti mode is not supported
A.IGP and RSVP
B.EBGPv4 with a sending community
C.IGP and EBGPv4
D.IGP and LDP
E.EBGPv4 with a sending label
A.hub and spoke
B.PE
C.CE
D.hub
E.spoke
A.privilege-level configuration
B.fabric cards
C.SNMP traps
D.admin- level configuration
E.exec- level configuration
A.All CE devices emulate a bridge
B.All provider devices emulate a bridge
C.Hierarchical VPLS reduces signaling overhead
D.Each PE device emulates a bridge
E.Each CE device emulates a bridge
A.TCP
B.UDP
C.HTTP
D.Multicast
A.It allows ITCM to send multiple upstream packets in one single large burst.
B.It reduces upstream data throughput.
C.It can be enabled/disabled from CMTS on per upstream port basis if desired
D.Concatenation activity on an interface can be checked by the show controller counters command
A.Turning the laser to a specific ITU channel
B.Keeping the signal wavelength "locked" to a specific technology
C.Suppressing FWM and SBS non-linear effects
D.None ofthe above
最新試題
How many messages does internet Key Exchange use to negotiate SA characteristics when running inmain mode？（）
When an MPLS Layer 2 VPN runs in the hub-and-spoke model， where is QoS implemented？（）
Which two routers support cable access？（）
Which three things are the building blocks of the Cisco VPLS architecture？（）
Which three statements about MPLS traffic engineering （MPLS TE） are true？ （）
Which configuration prevents traffic that is sourced from the unique local address scope to be sent out ofthe link to the upstream service provider？（）
Which statement about implementing the Cisco IPv6 provider Edge Router over MPLS is true？（）
Which Modular QoS CLI （MQC） based output queuing method is designed to support multiple trafficclasses including VoIP traffic， mission-critical traffic， interactive traffic， and default class traffic？（）
Which statement about VPLS is true？（）
There are two cabling schemes to choose from when implementing a Cisco CRS-1 multishelf system：single-module cabling and multimodule cabling. What is the maximum capacity of the LCCs that aresupported in multimodule cabling？（）