A.6PE feature is supported over tunnels other than RSVP-TE tunnels
B.Core MPLS routers are supporting IPv6 ONLY
C.6PE feature is not supported over tunnels other than RSVP-TE tunnels
D.Core MPLS routers are supporting IPv4 only
您可能感興趣的試卷
你可能感興趣的試題
A.The virtual routing and forwarding table is separate from the global routing table that exists on PE routers. Routes are injected into the VRF from the CE-PE routing protocols for that VRF and any MP-BGP announcements that match the defined VRF RTs
B.Multiprotocol Border Gateway Protocol is run between PE and CE routers to exchange customer prefixes in a VPNv4 format
C.A customer edge router peers at Layer 3 to the provider edge. The PE-CE interface runs either a dynamic routing protocol （eBGP， RIPv2， EIGRP， OSPF） or a static routing protocol （Static， Connected）
D.VPNv4 address is the combination of the RT and customer IPv4 prefix. These VPNv4 prefixes are passed in MP-BGP
A.EVC infrastructure is a Layer 3 platform-independent routing architecture that supports IP overEthernet services
B.Ethernet flow point （EFP） is configured on the main interface
C.Feature commands like MQC-based QoS policies can be specified
D.EVC infrastructure is a Layer 2 platform-independent bridging architecture that supports Ethernetservices
E.Each Ethernet flow point （EFP） matches a predefined VLAN tag-based criteria
F.Ethernet flow point （EFP） is configured on the VLAN interface
A.CSNP
B.LSP
C.ISH
D.Hello
E.IIH
F.PSNP
A.Show mpls Idp neighbor detail
B.Show mpls Idp bindings
C.Show mpls Idp parameters
D.Show mpls Idp discovery
A.Cisco Discovery Protocol
B.Label Discovery Protocol
C.Border Gateway Protocol
D.OSPF
E.RIP version 2
A.3 messages
B.6 messages
C.4 messages
D.2 messages
E.5 messages
A.Incorrect VPI and VCI configuration
B.Noise， gain hits， or other transmission problems on the data link equipment
C.ATM cells are dropped due to incorrect ATM routing in the service provider.
D.A faulty or failing ATM interface.
E.Cells are dropped due to traffic policing in the ATM cloud on one or more virtual circuits attached to theATM interface
A.CBWFQ
B.CB-WRED
C.LLQ
D.Custom Queueing
E.WRR Queueing
A.VLAN Trunk Protocol （VTP）
B.State Synchronization Protocol （SSP）
C.L2VPN
D.Ethernet Virtual Switch Interface （VSI）
E.Label Distribution Protocol （LDP）
A.9 LCCs
B.7 LCCs
C.10 LCCs
D.6 LCCs
E.8 LCCs
最新試題
Which option describes a benefits of IPv6 VPN Provider Edge？（）
When an MPLS Layer 2 VPN runs in the hub-and-spoke model， where is QoS implemented？（）
Two islands of IPv6 networks that are running ISIS （IPv6 IGP） must be connected using a tunnel over anIPv4 network. Which tunneling method can be used to achieve this goal？（）
Which statement is FALSE concerning Concatenation？（）
What layer of the TMN （telecommunications management network） model does CTM fit into？（）
Which option is not a valid method to assign the lowest-order 64-bit field of an IPv6 unicast address？（）
Which information is carried in the OSPFv3 intra-area Prefix LSA？（）
Which statement about the use of Route Target Rewrite is true？（）
Which three are advantages of SONET？（）
How many messages does internet Key Exchange use to negotiate SA characteristics when running inmain mode？（）