A.ME3000
B.UBR10000
C.ASR9000
D.CRS-1
E.ME3600
F.UBR7200
您可能感興趣的試卷
你可能感興趣的試題
A.1
B.None
C.3
D.2
E.It depends on the numbers of hops between the ingress and egress PE
A.Provider support for intra-AS and CSC scenarios
B.Uses separate signaling plane， which provides more security than IPv4
C.BGP is the preferred routing protocol for connecting two SPs
D.No requirement for a separate signaling plane
A.The MDT group address should be the same for both address families in the same VRF
B.The MDT group address should be the same for both address families in the different VRFs
C.Configuration of the MDT source on a pre-VRF basis is supported only on IPv6
D.The MDT group address should be different for both address families in the same VRF
A.GRE tunnels
B.automatic 6 to 4 tunnels
C.ISATAP tunnels
D.manual tunnels （RFC 2893）
A.MPLS is enabled on the core， distribution， and edge devices.
B.A triple stack is enabled on PE devices.
C.The network has at least six PE devices.
D.A dual stack is enabled on all the P and PE devices in a network.
A.IPv4 packets are carried over IPv6 tunnels to the LSN while IPv6 traffic is forwarded natively.
B.Ipv6 packets are carried over IPv4 tunnels to the LSN while IPv4 traffic is forwards natively.
C.The LSN performs NAT44 on private IPv4 source addresses.
D.DS-Lite does not perform any address translation.
A.interface Ethernet0/0 I.pv6 traffic-filter NoULA out I.pv6 access-list NoULA Deny ipv6 FC00：：/8 any Permit ipv6 any any
B.interface Ethernet0/0 I.pv6 traffic-filter NoULA out I.pv6 access-list NoULA Deny ipv6 FC00：：/7 anyP ermit ipv8 any any
C.interface Ethernet0/0 I.pv6 access-group NoULA out I.pv6 access-list NoULA Deny ipv6 FC00：：/8 anyP ermit ipv6 any any
D.interface Ethernet0/0 I.pv6 access-group NoULA out I.pv6 access-list NoULA Deny ipv6 FC00：：/7 any Permit ipv6 any any
A.all link-local addresses
B.all IPv6 prefix and topology information that OSPFv2 included in Router LSA and Network LSA
C.list of options associated with the link to all other routers attached to the link
D.all prefix-specific information that OSPFv2 included in Router LSA and Network LSA
A.6PE feature is supported over tunnels other than RSVP-TE tunnels
B.Core MPLS routers are supporting IPv6 ONLY
C.6PE feature is not supported over tunnels other than RSVP-TE tunnels
D.Core MPLS routers are supporting IPv4 only
A.The virtual routing and forwarding table is separate from the global routing table that exists on PE routers. Routes are injected into the VRF from the CE-PE routing protocols for that VRF and any MP-BGP announcements that match the defined VRF RTs
B.Multiprotocol Border Gateway Protocol is run between PE and CE routers to exchange customer prefixes in a VPNv4 format
C.A customer edge router peers at Layer 3 to the provider edge. The PE-CE interface runs either a dynamic routing protocol （eBGP， RIPv2， EIGRP， OSPF） or a static routing protocol （Static， Connected）
D.VPNv4 address is the combination of the RT and customer IPv4 prefix. These VPNv4 prefixes are passed in MP-BGP
最新試題
MPLS label mapping on an LSR is displayed by which IOS command？（）
Which statement about VPLS is true？（）
Which configuration prevents traffic that is sourced from the unique local address scope to be sent out ofthe link to the upstream service provider？（）
Which two statements about Layer 3 MPLS VPN are true？（）
Which four statements about Ethernet virtual circuit （EVC） infrastructure are true？ （）
Which two requirements to deploy 6PE and 6VPE solutions are mandatory？（）
Two islands of IPv6 networks that are running ISIS （IPv6 IGP） must be connected using a tunnel over anIPv4 network. Which tunneling method can be used to achieve this goal？（）
Which three statements about MPLS traffic engineering （MPLS TE） are true？ （）
Which three protocols use TLVs to carry attributes？（）
Which Modular QoS CLI （MQC） based output queuing method is designed to support multiple trafficclasses including VoIP traffic， mission-critical traffic， interactive traffic， and default class traffic？（）