A. All TCP traffic is marked discard eligible.
B. All UDP traffic is marked discard eligible and a BECN is sent.
C. All TCP traffic is marked discard eligible and a BECN is sent.
D. All traffic exceeding the CIR is marked discard eligible.
您可能感興趣的試卷
你可能感興趣的試題
A. Visually verify the MAC addresses and then telnet to the switches to enter the switchport-port security mac-address command.
B. Have end users e-mail their MAC addresses. Telnet to the switch to enter the switchport-port security mac-address command.
C. Use the switchport port-security MAC address sticky command on all the switch ports that have end devices connected to them.
D. Use show mac-address-table to determine the addresses that are associated with each port and then enter the commands on each switch for MAC address port-security.
A. A CSU/DSU converts analog signals from a router to a leased line; a modem converts analog signals from a router to a leased line.
B. A CSU/DSU converts analog signals from a router to a phone line; a modem converts digital signals from a router to a leased line.
C. A CSU/DSU converts digital signals from a router to a phone line; a modem converts analog signals from a router to a phone line.
D. A CSU/DSU converts digital signals from a router to a leased line; a modem converts digital signals from a router to a phone line.
A. show reload
B. show boot
C. show running-config
D. show version
A. LAN
B. routing
C. WAN
D. network
A. presentation
B. session
C. transport
D. network
E. physical
A. transport
B. network
C. presentation
D. session
E. application
A. minimum cell rate (MCR)
B. quality of service (QoS)
C. modulation
D. packet switching exchange (PSE)
E. reliable transport protocol (RTP)
A. bandwidth
B. delay
C. load
D. reliability
A. atm-dxi
B. frame-relay
C. hdlc
D. lapb
E. ppp
A. show protocols
B. show process
C. show system
D. show version
最新試題
How are VTP advertisements delivered to switches across the network?()
A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0
What is the purpose of the cisco Vlan Trunking protocol?()
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()
Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()
Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()
Three access ports have been installed and configured to a small office.What term defines the wireless topology?()
Which pairing reflects a correct protocol-and-metric relationship?()
What is the subnetwork address for a host with the IP address 201.100.5.68/28?()