多項選擇題Why do large OSPF networks use a hierarchical design?()

A. to confine network instability to single areas of the network.
B. to reduce the complexity of router configuration
C. to speed up convergence
D. to lower costs by replacing routers with distribution layer switches
E. to decrease latency by increasing bandwidth
F. to reduce routing overhead


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題What are three features of the IPV6 protocol?()

A.complicated header
B.plug-and-play
C.no broadcasts
D.checksums
E.optional IPsec
F.autoconfiguration

2.多項選擇題Which two statements about static NAT translations are true?()

A. They are always present in the NAT table.
B. They allow connection to be initiated from the outside.
C. They can be configured with access lists, to allow two or more connections to be initiated from the outside.
D. They require no inside or outside interface markings because addresses are statically defined.

3.多項選擇題Which three statements about RSTP are true?()

A. RSTP significantly reduces topology reconverging time after a link failure.
B. RSTP expends the STP port roles by adding the alternate and backup roles.
C. RSTP port atates are blocking,discarding,learing,or forwarding.
D. RSTP also uses the STP proprsal-agreement sequence.
E. RSTP use the same timer-baseed process as STP on point-to-point links.
F. RSTP provides a faster transition to the forwarding state on point-to-point links than STP does.

4.多項選擇題What are two benefits of using NAT?()

A. NAT protects network security because private networks are not advertised.
B. NAT accelerates the routing process because no modifications are made on the packets.
C. Dynamic NAT facilitates connections from the outside of the network.
D. NAT facilitates end-to-end communication when IPsec is enable.
E. NAT eliminates the need to re-address all host that require extemal access.
F. NAT conserves addresses through host MAC-level multiplexing.

5.多項選擇題Which two commands correctly verify whether port security has been configured on port FastEthernet 0/12 on a switch?()

A. SW1#show swithport port-security interface FastEthernet 0/12
B. SW1# show swithport port-secure interface FastEthernet 0/12
C. SW1# show port-secure interface FastEthernet 0/12
D. SW1#show running-config
E. SW1#show port-security interface FastEthernet 0/12

6.多項選擇題In an Ethernet network, under what two scenarios can devices transmit?()

A. when they receive a special token
B. when there is a carrier
C. when they detect no other devices are sending
D. when the medium is idle
E. when the server grants access

7.多項選擇題By default, each port in a Cisco Catalyst switch is assigned to VLAN1. Which two recommendations are key to avoid unauthorized management access?()

A. Create an additional ACL to block the access to VLAN 1.
B. Move the management VLAN to something other than default.
C. Move all ports to another VLAN and deactivate the default VLAN.
D. Limit the access in the switch using port security configuration.
E. Use static VLAN in trunks and access ports to restrict connections.
F. Shutdown all unused ports in the Catalyst switch.

8.多項選擇題Which of the following correctly describe steps in the OSI data encapsulation process?()

A. The transport layer divides a data stream into segments and may add reliability and flow control information.
B. The data link layer adds physical source and destination addresses and an FCS to the segment.
C. Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information.
D. Packets are created when the network layer adds Layer 3 addresses and control information to a segment.
E. The presentation layer translates bits into voltages for transmission across the physical link.

9.多項選擇題Which three of these statements regarding 802.1Q trunking are correct?()

A. 802.1Q native VLAN frames are untagged by default.
B. 802.1Q trunking ports can also be secure ports.
C. 802.1Q trunks can use 10 Mb/s Ethernet interfaces.
D. 802.1Q trunks require full-duplex, point-to-point connectivity.
E. 802.1Q trunks should have native VLANs that are the same at both ends.

10.多項選擇題Which two of these statements regarding RSTP are correct?()

A. RSTP cannot operate with PVST+.
B. RSTP defines new port roles.
C. RSTP defines no new port states.
D. RSTP is a proprietary implementation of IEEE 802.1D STP.
E. RSTP is compatible with the original IEEE 802.1D STP.

最新試題

Which statement describes the rule of split horizon?()

題型:單項選擇題

On which options are standard access list based?()

題型:單項選擇題

Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()

題型:單項選擇題

How are VTP advertisements delivered to switches across the network?()

題型:單項選擇題

What is the purpose of the cisco Vlan Trunking protocol?()

題型:單項選擇題

Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()

題型:單項選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:單項選擇題

What is the subnetwork address for a host with the IP address 201.100.5.68/28?()

題型:單項選擇題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

題型:單項選擇題

A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()

題型:單項選擇題