您可能感興趣的試卷
你可能感興趣的試題
A.Increase MTU of the interfaces to accommodate larger OSPF packets.
B.Change the network type to point-to-point on those links.
C.Reduce SPF initial timer.
D.Increase hello interval to avoid adjacency flapping.
E.Enable OSPF
A.examine all packets received to make sure that the source addresses and source interfaces appear in the routing table and match the interfaces where the packets were received
B.check to see if any packet received at a router interface arrives on the best return path
C.combine with a configured ACL
D.log its events,if you specify the logging options for the ACL entries used by the unicast rpf command
E.inspect IP packets encapsulated in tunnels, such as GRE
A.It is applied only on the input interface of a router.
B.It is applied only on the output interface of a router.
C.It can be configured either on the input or output interface of a router.
D.It cannot be configured on a router interface.
E.It is configured under any routing protocol process.
A.Configure a routing process using the command ipv6 router ospf [process-id].
B.Add the network statement for the interfaces on which OSPF will run.
C.Configure OSPF on the interface that it will run on.
D.Use the passive-interface command on the interfaces on which OSPF should not run.
E.Enable routing.
A.BGP peers must be Layer 2-adjacent.
B.EBGP multihop is not configured.
C.The firewall is not configured to allow IP protocol 89.
D.The firewall is not configured to allow UDP 179.
A.route redistribution
B.import and export using route descriptors
C.import and export using route targets
D.Cisco MPLS Traffic Engineering
最新試題
R1 will choose which path to reach 10.1.0.0?
what is the disadvantage of policing?
four switches, which one will be root switch.(no pic).
what is the advantage of policing opposite to shaping?
當將多個交換機加入到MST region當中會發生什么(what happen)?
Refer to the exhibit.Which statement describes DLCI 17?()
什么是NAT?
SPT初始狀態之后的一個狀態是什么?
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?()
QoS Mechanisms:問在部署QoS中要用的3個mechanisms是什么?