A.examine all packets received to make sure that the source addresses and source interfaces appear in the routing table and match the interfaces where the packets were received
B.check to see if any packet received at a router interface arrives on the best return path
C.combine with a configured ACL
D.log its events，if you specify the logging options for the ACL entries used by the unicast rpf command
E.inspect IP packets encapsulated in tunnels， such as GRE
您可能感興趣的試卷
你可能感興趣的試題
A.It is applied only on the input interface of a router.
B.It is applied only on the output interface of a router.
C.It can be configured either on the input or output interface of a router.
D.It cannot be configured on a router interface.
E.It is configured under any routing protocol process.
A.Configure a routing process using the command ipv6 router ospf [process-id].
B.Add the network statement for the interfaces on which OSPF will run.
C.Configure OSPF on the interface that it will run on.
D.Use the passive-interface command on the interfaces on which OSPF should not run.
E.Enable routing.
A.BGP peers must be Layer 2-adjacent.
B.EBGP multihop is not configured.
C.The firewall is not configured to allow IP protocol 89.
D.The firewall is not configured to allow UDP 179.
A.route redistribution
B.import and export using route descriptors
C.import and export using route targets
D.Cisco MPLS Traffic Engineering
A.LSA 1
B.LSA 3
C.LSA 4
D.LSA 5
E.LSA 7
A.IP prefix
B.Layer 2 circuit
C.RSVP request from CE for bandwidth reservation
D.BGP MED value
A.They are used to summarize area routes to other areas.
B.They are used in not-so-stubby areas to propagate external routes.
C.They are used to notify areas of the ASBR.
D.They are flooded to all areas except stub areas （external route）.
A.The Layer 2 multicast address of the destination node
B.The solicited node multicast address of the destination node
C.The Layer 2 address of the destination node based on the destination IPv6 address
D.The IPv6 address of the destination node based on the destination Layer 2 address
A.CEF
B.FIB
C.LFIB
D.IGP
最新試題
When upgrading the IOS image,the network administrator receives the exhibited error message.What could be the cause of this error?（）
what is the disadvantage of policing？
Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）
Local Preference？
當將多個交換機加入到MST region當中會發生什么（what happen）？
兩ebgp鄰居發路由過來 ，哪些屬性重置？
Refer to the exhibit.How many broadcast domains exist in theexhibited topology？（）
What field in IP packet is used for classification by QOS？
What is the next state of initial in spanning-tree protocol？
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?（）