A.It is applied only on the input interface of a router.
B.It is applied only on the output interface of a router.
C.It can be configured either on the input or output interface of a router.
D.It cannot be configured on a router interface.
E.It is configured under any routing protocol process.
您可能感興趣的試卷
你可能感興趣的試題
A.Configure a routing process using the command ipv6 router ospf [process-id].
B.Add the network statement for the interfaces on which OSPF will run.
C.Configure OSPF on the interface that it will run on.
D.Use the passive-interface command on the interfaces on which OSPF should not run.
E.Enable routing.
A.BGP peers must be Layer 2-adjacent.
B.EBGP multihop is not configured.
C.The firewall is not configured to allow IP protocol 89.
D.The firewall is not configured to allow UDP 179.
A.route redistribution
B.import and export using route descriptors
C.import and export using route targets
D.Cisco MPLS Traffic Engineering
A.LSA 1
B.LSA 3
C.LSA 4
D.LSA 5
E.LSA 7
A.IP prefix
B.Layer 2 circuit
C.RSVP request from CE for bandwidth reservation
D.BGP MED value
A.They are used to summarize area routes to other areas.
B.They are used in not-so-stubby areas to propagate external routes.
C.They are used to notify areas of the ASBR.
D.They are flooded to all areas except stub areas (external route).
A.The Layer 2 multicast address of the destination node
B.The solicited node multicast address of the destination node
C.The Layer 2 address of the destination node based on the destination IPv6 address
D.The IPv6 address of the destination node based on the destination Layer 2 address
A.CEF
B.FIB
C.LFIB
D.IGP
A.Be = 46320000 ,Bc = 96000
B.Be = 768000 ,Bc = 32000
C.Be = 128000 ,Bc = 7680
D.Be = 0 ,Bc = 96000
最新試題
Refer to the exhibit.Which statement describes DLCI 17?()
four switches, which one will be root switch.(no pic).
兩ebgp鄰居發路由過來 ,哪些屬性重置?
Local Preference?
What is the next state of initial in spanning-tree protocol?
Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?()
問一個怎么樣的屬性,能讓路由不通告給任何的peer?
A default Frame Relay WAN is classified as what type of physical network?()
How should arouter that is being used in a Frame Relay network be configured to avoid split horizon issues from preventing routing updates?()
When upgrading the IOS image,the network administrator receives the exhibited error message.What could be the cause of this error?()