A.excessive collisions
B.FCS errors
C.runts
D.late collisions
您可能感興趣的試卷
你可能感興趣的試題
A.interface gig3/1 spanning-tree guard root
B.interface gig3/1 spanning-tree root guard
C.interface gig3/1 spanning-tree root-guard
D.interface gig3/1 spanning-tree root-guard default
A. prefixes received from any other BGP peer and prefixes locally originated via network statements or redistributed
B. all prefixes in its routing table
C. prefixes received from EBGP peers and prefixes locally originated via network statements or redistributed
D. prefixes received from EBGP peers and prefixes received from route reflectors
E. prefixes received from other IBGP peers, prefixes received from EBGP peers, and prefixes redistributed to BGP
F. prefixes received from other IBGP peers and prefixes received from route reflectors
A.802.1s supports a reduced number of spanning-tree instances.
B.802.1s has better convergence times than 802.1w.
C.802.1s does not support load balancing over the same physical topology.
D.The CPU utilization for 802.1s is lower than the CPU utilization for 802.1w.
A.service timestamps log datetimec msec
B.logging timestamps msec
C.syslog timestamps hour minute second miliseconds
D.service logging timestamp msec
E.logging service timestamp msec
A.version 1
B.version 5
C.version 7
D.version 8
E.version 9
A.ip sla 1 icmp-echo 1.1.1.1 tos 12
B.ip sla 1 icmp-echo 1.1.1.1 tos 96
C.ip sla 1 icmp-echo 1.1.1.1 precedence 3
D.ip sla 1 icmp-echo 1.1.1.1 dscp 12
A.ip sla monitor low-memory
B.ip sla group schedule
C.ip sla reaction-trigger
D.ip sla enable timestamp
Refer to the exhibit. In this network, R1 is configured not to perform autosummarization within EIGRP. What routes will R3 learn from R2 through EIGRP? ()
A. 172.30.1.0/24 and 10.1.2.0/24;EIGRP only performs autosummarization at the edge between two major networks.
B. 172.30.0.0/16 and 10.1.2.0/24;R2 will perform autosummarization although R1 will not.
C. Since R2 is configured without autosummarization, it will not propagate the 172.30.1.0/24 route.
D. 172.30.0.0/8 and 10.0.0.0/8.
Refer to the exhibit. In this network, R1 has been configured to advertise a summary route, 192.168.0.0/22, to R2. R2 has been configured to advertise a summary route, 192.168.0.0/21, to R1. Both routers have been configured to remove the discard route (the route to null created when a summary route is configured) by setting the administrative distance of the discard route to 255. What will happen if R1 receives a packet destined to 192.168.3.1?()
A. The packet will loop between R1 and R2.
B. It is not possible to set the administrative distance on a summary to 255.
C. The packet will be forwarded to R2, where it will be routed to null0.
D. The packet will be dropped by R1, since there is no route to 192.168.3.1.
A.Upgrade the switches
B.Configure BPDU guard
C.Configure VLAN access lists
D.Configure port security
E.Configure Dynamic ARP inspection
最新試題
What is also called Type 0 authentication in OSPF on Cisco Routers?()
When STP UplinkFast is enabled on a switch utilizing the default bridge priority, what will the new bridgepriority be changed to?()
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D?()
Which three message types are valid PIMv2 message types?()
How does an IPv6 router deal with a packet that is larger than the outgoing interface MTU?()
An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each,terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs,and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem?()
Based on the output provided in the exhibit, to which address or location will the router forward a packet sent to 192.168.32.1?()
The classic Spanning Tree Protocol (802.1 D 1998) uses which sequence of variables to determine thebest received BPDU?()
Which two statements about SA caching are true?()
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0?()