A.It will advertise the prefix to all other client peers and non-client peers.
B.It will not advertise the prefix to EBGP peers.
C.It will only advertise the prefix to all other IBGP peers.
D.It will not advertise the prefix to any peers.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Which switching feature is being tested？（）
A. loop guard
B. PortFast
C. root guard
D. BDPU guard
A.Prepend extra AS hops to the BGP prefix.
B.Advertise more specific BGP prefixes （longer mask）.
C.Add （prepend） one or more communities to the prefix that is advertised by BGP.
D.Have BGP dampen the prefix.
A.On/On
B.On/Auto
C.Passive/Active
D.Desirable/Auto
E.Active/Active
F.Desirable/Desirable
A.The VLAN to instance mapping is a normal 16-byte field in the MST BPDU.
B.The VLAN to instance mapping is a normal 12-byte field in the MST BPDU.
C.The VLAN to instance mapping is a 16-byte MD5 signature field in the MST BPDU.
D.The VLAN to instance mapping is a 12-byte MD5 signature field in the MST BPDU.
A.lowest root bridge ID
B.lowest path cost to root bridge
C.lowest sender bridge ID
D.highest port ID
E.highest root bridge ID
F.highest path cost to root bridge
A.VTPv3 supports 8K VLANs.
B.VTPv3 supports private VLAN mapping.
C.VTPv3 allows for domain discovery.
D.VTPv3 uses a primary server concept to avoid configuration revision issues.
E.VTPv3 is not compatible with VTPv1 or VTPv2.
F.VTPv3 has a hidden password option.
A. interface bandwidth
B. interface delay
C. interface bandwidth and delay
D. hop count
E. bridge priority
A. Loop guard can be used with root guard simultaneously on the same port on the same VLAN while UDLD cannot
B. UDLD protects against STP failures caused by cabling problems that create one-way links.
C. Loop guard detects and protects against duplicate packets being received and transmitted on different ports
D. UDLD protects against unidirectional cabling problems on copper and fiber media.
E. Loop guard protects against STP failures caused by problems that result in the loss of BPDUs from a designated switch port.
A.followers field
B.MD5 digest
C.VLAN information
D.sequence number
Refer to the exhibit. In the diagram，the switches are running IEEE 802.1w RSPT. On which ports should root guard be enabled in order to facilitate deterministic root bridge election under normal and failure scenarios？（）
A. GE-3/1， GE-3/2
B. FE-2/1， FE-3/2
C. GE-1/1， GE-1/2
D. GE-4/1， GE-4/2
E. GE-2/1， GE-2/2
F. GE-3/1， GE-3/2， GE-4/1， GE-4/2， FE-2/1， FE-3/2
最新試題
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）
Which two statements about SA caching are true？（）
An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each，terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs，and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem？（）
What is the correct command to set the router ID for an OSPFv3 process？（）
Choose two commands that are required to enable multicast on a router， when it is known that thereceivers use a specific functionality of IGMPv3.（）
What is true about Unicast RPF in strict mode？（）
What is also called Type 0 authentication in OSPF on Cisco Routers？（）
Which protocol and port have been assigned by IANA for RADIUS authentication？（）
Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these？（）
Which multicast address is reserved for cisco-rp-discovery？（）