A.Prepend extra AS hops to the BGP prefix.
B.Advertise more specific BGP prefixes (longer mask).
C.Add (prepend) one or more communities to the prefix that is advertised by BGP.
D.Have BGP dampen the prefix.
您可能感興趣的試卷
你可能感興趣的試題
A.On/On
B.On/Auto
C.Passive/Active
D.Desirable/Auto
E.Active/Active
F.Desirable/Desirable
A.The VLAN to instance mapping is a normal 16-byte field in the MST BPDU.
B.The VLAN to instance mapping is a normal 12-byte field in the MST BPDU.
C.The VLAN to instance mapping is a 16-byte MD5 signature field in the MST BPDU.
D.The VLAN to instance mapping is a 12-byte MD5 signature field in the MST BPDU.
A.lowest root bridge ID
B.lowest path cost to root bridge
C.lowest sender bridge ID
D.highest port ID
E.highest root bridge ID
F.highest path cost to root bridge
A.VTPv3 supports 8K VLANs.
B.VTPv3 supports private VLAN mapping.
C.VTPv3 allows for domain discovery.
D.VTPv3 uses a primary server concept to avoid configuration revision issues.
E.VTPv3 is not compatible with VTPv1 or VTPv2.
F.VTPv3 has a hidden password option.
A. interface bandwidth
B. interface delay
C. interface bandwidth and delay
D. hop count
E. bridge priority
A. Loop guard can be used with root guard simultaneously on the same port on the same VLAN while UDLD cannot
B. UDLD protects against STP failures caused by cabling problems that create one-way links.
C. Loop guard detects and protects against duplicate packets being received and transmitted on different ports
D. UDLD protects against unidirectional cabling problems on copper and fiber media.
E. Loop guard protects against STP failures caused by problems that result in the loss of BPDUs from a designated switch port.
A.followers field
B.MD5 digest
C.VLAN information
D.sequence number
Refer to the exhibit. In the diagram,the switches are running IEEE 802.1w RSPT. On which ports should root guard be enabled in order to facilitate deterministic root bridge election under normal and failure scenarios?()
A. GE-3/1, GE-3/2
B. FE-2/1, FE-3/2
C. GE-1/1, GE-1/2
D. GE-4/1, GE-4/2
E. GE-2/1, GE-2/2
F. GE-3/1, GE-3/2, GE-4/1, GE-4/2, FE-2/1, FE-3/2
A.runts
B.FCS errors
C.interface resets
D.late collisions
A.mpls ip cef
B.port-channel ip cef
C.mpls ip port-channel cef
D.port-channel load balance
E.mpls ip load-balance
F.ip cef EtherChannel channel-id XOR L4
G.ip cef connection exchange
最新試題
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router?()
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain?()
Which two statements are true about RED?()
Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these?()
Which three options are valid ways to filter routes from a BGP peer?()
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0?()
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer, assuming it is notconfigured as a route reflector?()
Which two are differences between IGMPv2 and IGMPv3 reports?()
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link,but only allow eachindividual flow to use 1 MB/s?()
Which of these statements about penultimate hop popping are true?()