A.enforce the placement of the root bridge in the network
B.ensure that a port is transitioned to a forwarding state quickly if a BPDU is received
C.enforce the borders of an STP domain
D.ensure that any BPDUs received are forwarded into the STP domain
您可能感興趣的試卷
你可能感興趣的試題
A.ip pim rp-address
B.ip pim ssm
C.ip pim sparse-mode
D.ip pim passive
A. Designated Root Cost
B. bridge ID priority
C. max age
D. bridge ID MAC address
E. Designated Root Priority
F. forward delay
A. one global STP instance for all VLANs
B. one STP instance for each VLAN
C. one STP instance per set of VLANs
D. one STP instance per set of bridges
最新試題
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router?()
In Layer 2 topologies, spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions?()
What is true about Unicast RPF in strict mode?()
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain?()
In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group?()
What is the correct command to set the router ID for an OSPFv3 process?()
Which three options are valid ways to filter routes from a BGP peer?()
Which three message types are valid PIMv2 message types?()
Which two are differences between IGMPv2 and IGMPv3 reports?()
Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall?()