A.The Gallant router has the wrong LMI type configured
B.Inverse ARP is providing the wrong PVC information to the Gallant router
C.The S3 interface of the Steele router has been configured with the frame-relay encapsulation ietf command
D.The frame-relay map statement in the Attalla router for the PVC to Steele is not correct
E.The IP address on the serial interface of the Attalla router is configured incorrectly

A.Configure a separate sub-interface for each PVC with a unique DLCI and subnet assigned to the subinterface B
B.Configure each Frame Relay circuit as a point-to-point line to support multicast and broadcast traffic
C.Configure many sub-interfaces on the same subnet
D.Configure a single sub-interface to establish multiple PVC connections to multiple remote router interfaces

A. buffering
B. cut-through
C. windowing
D. congestion avoidance
E. load balancing

A.A CSU/DSU terminates a digital local loop
B.A modem terminates a digital local loop
C.A CSU/DSU terminates an analog local loop
D.A modem terminates an analog local loop
E.A router is commonly considered a DTE device
F.A router is commonly considered a DCE device

A. 115.64.8.32
B. 115.64.7.64
C. 115.64.6.255
D. 115.64.3.255
E. 115.64.5.128
F. 115.64.12.128

A.can be used over analog circuits
B.maps Layer 2 to Layer 3 address
C.encapsulates several routed protocols
D.supports IP only
E.provides error correction

A.statically map IPV4 address to IPV6 addresses
B.configuration IPv4 tunnels between IPV6 islands
C.use DHCPv6 to map IPV4 addresses to IPV6 addresses
D.use proxying and translation to translate IPV6 packets into IPV4 packets
E.configure IPV6 directly
F.enable dual-stack routing

A.point-to-point
B.broadcast multi-access
C.nonbroadcast multi-access
D.nonbroadcast multipoint
E.broadcast point-to-multipoint

A.ermit all packets matching the first three octets of the source address to all destinations
B.permit all packet matching the last octet of the destination address and accept all source addresses
C.permit all packet matching the host bits in the source address to all destinations
D.permit all packet from the third subnet of the network address to all destinations

A. It supports VLSM.
B. It is used to route between autonomous systems.
C. It confines network instability to one area of the network.
D. It increases routing overhead on the network.
E. It allows extensive control of routing updates.
F. It is simpler to configure than RIP v2.