A.statically map IPV4 address to IPV6 addresses
B.configuration IPv4 tunnels between IPV6 islands
C.use DHCPv6 to map IPV4 addresses to IPV6 addresses
D.use proxying and translation to translate IPV6 packets into IPV4 packets
E.configure IPV6 directly
F.enable dual-stack routing
您可能感興趣的試卷
你可能感興趣的試題
A.point-to-point
B.broadcast multi-access
C.nonbroadcast multi-access
D.nonbroadcast multipoint
E.broadcast point-to-multipoint
A.ermit all packets matching the first three octets of the source address to all destinations
B.permit all packet matching the last octet of the destination address and accept all source addresses
C.permit all packet matching the host bits in the source address to all destinations
D.permit all packet from the third subnet of the network address to all destinations
A. It supports VLSM.
B. It is used to route between autonomous systems.
C. It confines network instability to one area of the network.
D. It increases routing overhead on the network.
E. It allows extensive control of routing updates.
F. It is simpler to configure than RIP v2.
A.VTP
B.802.1Q
C.RSTP
D.STP
A.FTP traffic from 192.169.1.22 will be denied
B.No traffic, except for FTP traffic will be allowed to exit E0
C.FTP traffic from 192.169.1.9 to any host will be denied
D.All traffic exiting E0 will be denied
E.All FTP traffic to network 192.169.1.9/29 will be denied
A. hello packets
B. SAP messages sent by other routers
C. LSAs from other routers
D. beacons received on point-to-point links
E. routing tables received from other link-state routers
F. TTL packets from designated routers
Refer to the exhibit.HostA cannot ping HostB.Assuming routing is properly configured,what could be thecause of this problem?()
A.HostA is not on the same subnet as its default gateway
B.The address of SwitchA is a subnet address
C.The Fa0/0 interface on RouterA is on a subnet that cannot be used
D.The serial interfaces of the routers are not on the same subnet
E.The Fa0/0 interface on RouterB is using a broadcast address
A.access-list 101 in
B.access-list 101 out
C.ip access-group 101 in
D.ip access-group 101 out
A.access-list 101 deny tcp 192.168.1.128 0.0.0.15 192.168.1.5 0.0.0.0 eq 23 access-list 101 permit ip any any
B.access-list 101 deny tcp 192.168.1.128 0.0.0.240 192.168.1.5 0.0.0.0 eq 23 access-list 101 permit ip any any
C.access-list 1 deny tcp 192.168.1.128 0.0.0.255 192.168.1.5 0.0.0.0 eq 21 access-list 1 permit ip any any
D.access-list 1 deny tcp 192.168.1.128 0.0.0.15 host 192.168.1.5 eq 23 access-list 1 permit ip any any
A.IR
B.DSSS
C.FHSS
D.DSSS and FHSS
E.IR,F(xiàn)HSS,and DSSS
最新試題
請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet。可以為路由器接口S0/0/0分配下列哪一個IP 地址?()
在配置路由器時,網絡技術人員想要命名路由器。輸入hostname 命令后,技術人員會看到下列哪一項提示?()
請參見圖示。從主機X 發出的到主機Y 的tracert 命令已成功。下列哪一項正確地反映了追蹤列表中顯示的中間網絡設備的順序?()
請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()
請參見圖示。主機A 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,路由器Y 的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為172.16.1.5而目的IP 地址為172.16.7.24的數據包。捕獲該幀時,它的源MAC 地址是什么?()
請參見圖示。主機A 和B 無法互相通信。此問題的原因是什么?()
請參見圖示。在網絡中,PC1向PC2發送了一條消息。PC2收到的幀如圖所示。該幀中的哪一信息確定了正確的目的應用程序?()
請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲写嬖诙嗌賯€(gè)廣播域?()
請參見圖示。網絡技術人員使用圖中所示的連接將主機A 連接到路由器以創建初始配置。下列有關此連接的陳述中哪一項正確?()
請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置?()