A.Host 1 addresses the frames to the MAC address of router R1
B.Host 1 looks in its ARP cache for the MAC address of router R1
C.Host 1 addresses the frames to the MAC address of web server 2
D.Host 1 sends the packets to router R1 to be forwarded to web server 2
E.Host 1 sends a broadcast ARP request to obtain the MAC address of webserver2

A.reflexive
B.extended
C.standard
D.dynamic

A.they offer simpler management in large internetworks.
B.you can control logging messages.
C.they allow packets to be filtered based on upper-layer session information.
D.you can set a time-based security policy.
E.they provide a level of security against spoofing.
F.they are used to authenticate individual users

A.A hub is connected directly to FastEthernet0/5
B.FastEthernet0/1 is configured as a trunk link.
C.FastEthernet0/5 has statically assigned mac address
D.Interface FastEthernet0/2 has been disable.
E.Multiple devices are connected directly to FastEthernet0/1.
F.FastEthernet0/1 is connected to a host with multiple network interface cards.

A.24
B.4
C.8
D.16

A.switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security maximum 1
B.switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security mac-address 1
C.switch(config-if)#switchport mode access switch(config-if)#switchport port-security maximum 1
D.switch(config-if)#switchport mode access switch(config-if)#switchport port-security mac-address 1

A.The IP address for Server A is a broadcast address.
B.The IP address for Workstation B is a subnet address.
C.The gateway for Workstation B is not on the same subnet.
D.The gateway for Server A is not on the same subnet.

A.The switchport belongs only to VLAN 2
B.Interface fa0/0 will be in both VLAN 1 (by default) and VLAN 2
C.The exhibit shows interface fa0/0 to be dynamically mapped to VLAN 2
D.A network host can be connected to this interface

A. A remote physical layer problem exists.
B. The host NIC is not functioning.
C. TCP/IP has not been correctly installed on the host.
D. A local physical layer problem exists.

A.switch to switch
B.switch to hub
C.switch to router
D.hub to hub
E.router to PC