A.24
B.4
C.8
D.16
您可能感興趣的試卷
你可能感興趣的試題
A.switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security maximum 1
B.switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security mac-address 1
C.switch(config-if)#switchport mode access switch(config-if)#switchport port-security maximum 1
D.switch(config-if)#switchport mode access switch(config-if)#switchport port-security mac-address 1
Refer to the exhibit.The user at Workstation B reports that Server A cannot be reached.What is
preventing Workstation B from reaching Server A?()
A.The IP address for Server A is a broadcast address.
B.The IP address for Workstation B is a subnet address.
C.The gateway for Workstation B is not on the same subnet.
D.The gateway for Server A is not on the same subnet.
A.The switchport belongs only to VLAN 2
B.Interface fa0/0 will be in both VLAN 1 (by default) and VLAN 2
C.The exhibit shows interface fa0/0 to be dynamically mapped to VLAN 2
D.A network host can be connected to this interface
What is the under lying cause of this problem?()
A. A remote physical layer problem exists.
B. The host NIC is not functioning.
C. TCP/IP has not been correctly installed on the host.
D. A local physical layer problem exists.
A.switch to switch
B.switch to hub
C.switch to router
D.hub to hub
E.router to PC
A.The transport layer divides a data stream into segments and may add reliability and flow control information.
B.The data link layer adds physical source and destination addresses and an FCS to the segment.
C.Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information.
D.Packets are created when the network layer adds Layer 3 addresses and control information to a segment.
E.The presentation layer translates bits into voltages for transmission across the physical link.
A.802.1Q native VLAN frames are untagged by default.
B.802.1Q trunking ports can also be secure ports.
C.802.1Q trunks can use 10 Mb/s Ethernet interfaces.
D.802.1Q trunks require full-duplex, point-to-point connectivity.
E.802.1Q trunks should have native VLANs that are the same at both ends.
A.it is a layer 2 messaging protocol which maintains vlan configurations across network.
B.it includes an 8-bit field which specifies the priority of a frame.
C.it is used exclusively for tagging vlan frames and dose not address network reconvergence following switched network topology changes.
D.it modifies the 802.3 frame header,and thus requires that the FCS be recomputed.
E.it is a trunking protocol capable of carring untagged frames.
A.255.255.255.0
B.255.255.255.192
C.255.255.255.250
D.255.255.255.252
A.RSTP cannot operate with PVST+.
B.RSTP defines new port roles.
C.RSTP defines no new port states.
D.RSTP is a proprietary implementation of IEEE 802.1D STP.
E.RSTP is compatible with the original IEEE 802.1D STP.
最新試題
請參見圖示。網絡中的所有設備均使用默認配置。此拓撲中存在多少個廣播域?()
要將數據包發(fā)送到遠程網絡,應使用哪種設備?()
請參見圖示。對于從主機A 向Web 服務器發(fā)出的網頁請求,正確的目的套接字數字是什么?()
請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論?()
請參見圖示。網絡中的所有設備均使用默認配置。此拓撲中需要多少個邏輯地址范圍?()
請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()
路由器使用哪一項信息來確定源主機和目的主機之間的路徑?()
下列哪些是私有IP 地址的地址范圍?()
在Cisco IOS 設備中,啟動配置文件存儲于何處?()
請參見圖示。主機A 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,路由器Y 的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為172.16.1.5而目的IP 地址為172.16.7.24的數據包。捕獲該幀時,它的源MAC 地址是什么?()