A.Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link.
B.Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal.
C.Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth.
D.Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive.

A.172.25.78.243
B.172.25.98.16
C.172.25.72.0
D.172.25.94.255
E.172.25.96.17
F.172.25.100.16

A.A variance was configured for EIGRP autonomous system 109.
B.The EIGRP topology table displays all routes to a destination.
C.The EIGRP topology table shows only backup routes to a destination.
D.Multiple floating static routes were configured to network 192.168.81.0 via interface Serial0.

A.transparent
B.auto
C.on
D.desirable
E.client
F.forwarding

A.Make sure that the server can be reached across the network.
B.Check that authentication for TFTP access to the server is set.
C.Assure that the network server has adequate space for the IOS image.
D.Verify file naming and path requirements.
E.Make sure that the server can store binary files.
F.Adjust the TCP window size to speed up the transfer.

A.Replace the straight-through cable with a crossover cable
B.Change the subnet mask of the hosts to /25
C.Change the subnet mask of the hosts to /26
D.Change the address of Workstation A to 192.0.2.15
E.Change the address of Workstation B to 192.0.2.111

A.Switch1(config-if)# switchport port-security maximum 1
B.Switch1(config)# mac-address-table secure
C.Switch1(config)# access-list 10 permit ip host
D.Switch1(config-if)# switchport port-security violation shutdown
E.Switch1(config-if)# ip access-group 10

A.copier
B.microwave oven
C.toaster
D.cordless phone
E.IP phone
F.AM radio

A.Switch1 - Fa 0/2
B.Switch1 - Fa 0/9
C.Switch2 - Fa 0/3
D.Switch2 - Fa 0/4
E.Switch2 - Fa 0/8
F.Router - Fa 1/0

A.If RIPv2 is the routing protocol, only the path AD will be installed in the routing table by default.
B.If RIPv2 is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.
C.If EIGRP is the routing protocol, only the path AD will be installed in the routing table by default.
D.If EIGRP is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.
E.If EIGRP and OSPF are both running on the network, the EIGRP paths will be installed in the routing table.
F.If EIGRP and OSPF are both running on the network, the OSPF paths will be installed in the routing table.