多項選擇題How will router A choose a path to the 10.1.2.0/24 network when different routing protocols are configured (Choose three.)()。

A.If RIPv2 is the routing protocol, only the path AD will be installed in the routing table by default.
B.If RIPv2 is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.
C.If EIGRP is the routing protocol, only the path AD will be installed in the routing table by default.
D.If EIGRP is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.
E.If EIGRP and OSPF are both running on the network, the EIGRP paths will be installed in the routing table.
F.If EIGRP and OSPF are both running on the network, the OSPF paths will be installed in the routing table.


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題Which of the following describe private IP addresses? ()

A.addresses chosen by a company to communicate with the Internet
B.addresses that cannot be routed through the public Internet
C.addresses that can be routed through the public Internet
D.a scheme to conserve public addresses
E.addresses licensed to enterprises or ISPs by an Internet registry organization

3.多項選擇題Which of the following are types of flow control (Choose three.)()。

A.buffering
B.cut-through
C.windowing
D.congestion avoidance
E.load balancing

4.單項選擇題How should a router that is being used in a Frame Relay network be configured to avoid split horizon issues from preventing routing updates?()

A.Configure a separate sub-interface for each PVC with a unique DLCI and subnet assigned to the sub-interface
B.Configure each Frame Relay circuit as a point-to-point line to support multicast and broadcast traffic
C.Configure many sub-interfaces on the same subnet
D.Configure a single sub-interface to establish multiple PVC connections to multiple remote router interfaces

6.單項選擇題Acknowledgements, sequencing, and flow control are characteristics of which OSI layer()。

A.Layer2
B.Layer3
C.Layer4
D.Layer5
E.Layer6
F.Layer7

7.單項選擇題When a new trunk link is configured on an IOS based switch, which VLANs are allowed over the link()。

A.By default, all defined VLANs are allowed on the trunk.
B.Each single VLAN, or VLAN range, must be specified with the switchport mode command.
C.Each single VLAN, or VLAN range, must be specified with the vtp domain command.
D.Each single VLAN, or VLAN range, must be specified with the vlan database command.

8.單項選擇題What is one benefit of PVST+?()

A.PVST+reduces the CPU cycles for all the switches in the network
B.PVST+automatically selects the root bridge location,to provide optimiz…
C.PVST+allow the root switch location to be optimized per vlan.
D.PVST+supports Layer 3 load balancing without loops.

9.單項選擇題When a router is connected to a Frame Relay WAN link using a serial DTE interface, how is the interface clock rate determined()。

A.It is supplied by the CSU/DSU.
B.It is supplied by the far end router.
C.It is determined by the clock rate command.
D.It is supplied by the Layer 1 bit stream timing.

10.多項選擇題

Refer to the diagram. Which three statements describe the router port configuration and the switch port configuration as shown in the topology? ()

A.The Router1 WAN port is configured as a trunking port.
B.The Router1 port connected to Switch1 is configured using subinterfaces.
C.The Router1 port connected to Switch1 is configured as 10 Mbps.
D.The Switch1 port connected to Router1 is configured as a trunking port.
E.The Switch1 port connected to Host B is configured as an access port.
F.The Switch1 port connected to Hub1 is configured as full duplex.

最新試題

請參見圖示。公司路由器由于故障被更換。更換路由器之后,Education 辦公室內的主機C 和D 能夠相互ping 通,但是無法訪問Accounts 辦公室內的主機。此問題的原因可能是什么?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述,哪兩項是正確的?()

題型:多項選擇題

下列哪些是私有IP 地址的地址范圍?()

題型:多項選擇題

請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是,從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題?()

題型:?jiǎn)雾?xiàng)選擇題

在Cisco IOS 設備中,啟動配置文件存儲于何處?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時,它的目的MAC 地址是什么?()

題型:?jiǎn)雾?xiàng)選擇題

要將數據包發送到遠程網絡,應使用哪種設備?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。已啟用路由器的NAT 功能供PC 訪問Internet。可以為路由器接口S0/0/0分配下列哪一個IP 地址?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接?()

題型:多項選擇題

請參見圖示。網絡技術人員使用圖中所示的連接將主機A 連接到路由器以創建初始配置。下列有關此連接的陳述中哪一項正確?()

題型:?jiǎn)雾?xiàng)選擇題