A.Configure a separate sub-interface for each PVC with a unique DLCI and subnet assigned to the sub-interface
B.Configure each Frame Relay circuit as a point-to-point line to support multicast and broadcast traffic
C.Configure many sub-interfaces on the same subnet
D.Configure a single sub-interface to establish multiple PVC connections to multiple remote router interfaces
您可能感興趣的試卷
你可能感興趣的試題
Which routing protocols will support the following IP addressing scheme? （）
Network 1 - 192.168.10.0 /26
Network 2 - 192.168.10.64 /27
Network 3 - 192.168.10.96 /27
Network 4 - 192.168.10.128 /30
Network 5 - 192.168.10.132 /30
A.RIP version 1
B.RIP version 2
C.IGRP
D.EIGRP
E.OSPF
A.Layer2
B.Layer3
C.Layer4
D.Layer5
E.Layer6
F.Layer7
A.By default, all defined VLANs are allowed on the trunk.
B.Each single VLAN, or VLAN range, must be specified with the switchport mode command.
C.Each single VLAN, or VLAN range, must be specified with the vtp domain command.
D.Each single VLAN, or VLAN range, must be specified with the vlan database command.
A.PVST+reduces the CPU cycles for all the switches in the network
B.PVST+automatically selects the root bridge location,to provide optimiz…
C.PVST+allow the root switch location to be optimized per vlan.
D.PVST+supports Layer 3 load balancing without loops.
A.It is supplied by the CSU/DSU.
B.It is supplied by the far end router.
C.It is determined by the clock rate command.
D.It is supplied by the Layer 1 bit stream timing.
Refer to the diagram. Which three statements describe the router port configuration and the switch port configuration as shown in the topology? （）
A.The Router1 WAN port is configured as a trunking port.
B.The Router1 port connected to Switch1 is configured using subinterfaces.
C.The Router1 port connected to Switch1 is configured as 10 Mbps.
D.The Switch1 port connected to Router1 is configured as a trunking port.
E.The Switch1 port connected to Host B is configured as an access port.
F.The Switch1 port connected to Hub1 is configured as full duplex.
Refer to the diagram. All hosts have connectivity with one another. Which statements describe the addressing scheme that is in use in the network?（）
A.The subnet mask in use is 255.255.255.192.
B.The subnet mask in use is 255.255.255.128.
C.The IP address 172.16.1.25 can be assigned to hosts in VLAN1
D.The IP address 172.16.1.205 can be assigned to hosts in VLAN1
E.The LAN interface of the router is configured with one IP address.
F.The LAN interface of the router is configured with multiple IP addresses.
A.WAN switch
B.PVC
C.ATM switch
D.multiplexer
E.CSU/DSU
F.modem
A.A successor route is used by EIGRP to forward traffic to a destination.
B.Successor routes are saved in the topology table to be used if the primary route fails.
C.Successor routes are flagged as "active" in the routing table.
D.A successor route may be backed up by a feasible successor route.
E.Successor routes are stored in the neighbor table following the discovery process.
A.A WPA key is longer and requires more special characters than the WEP key.
B.The access point and the client are manually configured with different WPA key values.
C.WPA key values remain the same until the client configuration is changed.
D.The values of WPA keys can change dynamically while the system is used.
最新試題
在路由器上使用Router#copy running-config startup-config 命令會產生什么效果？（）
請參見圖示。公司路由器由于故障被更換。更換路由器之后，Education 辦公室內的主機C 和D 能夠相互ping 通，但是無法訪問Accounts 辦公室內的主機。此問題的原因可能是什么？（）
請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口？（）
OSI 哪一層可提供有序的數據重構服務？（）
請參見圖示。主機A 和B 無法互相通信。此問題的原因是什么？（）
傳輸層如何讓主機能同時針對不同應用程序維護多個通信流？（）
請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲行枰嗌賯€(gè)邏輯地址范圍？（）
請參見圖示。哪種邏輯拓?fù)涫菍?duì)圖示網絡的準確描述？（）
請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置？（）
路由器使用哪一項信息來確定源主機和目的主機之間的路徑？（）