A.Full-duplex Ethernet consists of a shared cable segment. Half-duplex Ethernet provides a point-to-point link.
B.Full-duplex Ethernet uses a loopback circuit to detect collisions. Half-duplex Ethernet uses a jam signal.
C.Full-duplex Ethernet can provide higher throughput than can half-duplex Ethernet of the same bandwidth.
D.Full-duplex Ethernet uses two wires to send and receive. Half-duplex Ethernet uses one wire to send and receive.
您可能感興趣的試卷
你可能感興趣的試題
A.172.25.78.243
B.172.25.98.16
C.172.25.72.0
D.172.25.94.255
E.172.25.96.17
F.172.25.100.16
A.A variance was configured for EIGRP autonomous system 109.
B.The EIGRP topology table displays all routes to a destination.
C.The EIGRP topology table shows only backup routes to a destination.
D.Multiple floating static routes were configured to network 192.168.81.0 via interface Serial0.
A.transparent
B.auto
C.on
D.desirable
E.client
F.forwarding
A.Make sure that the server can be reached across the network.
B.Check that authentication for TFTP access to the server is set.
C.Assure that the network server has adequate space for the IOS image.
D.Verify file naming and path requirements.
E.Make sure that the server can store binary files.
F.Adjust the TCP window size to speed up the transfer.
A.Replace the straight-through cable with a crossover cable
B.Change the subnet mask of the hosts to /25
C.Change the subnet mask of the hosts to /26
D.Change the address of Workstation A to 192.0.2.15
E.Change the address of Workstation B to 192.0.2.111
A.Switch1(config-if)# switchport port-security maximum 1
B.Switch1(config)# mac-address-table secure
C.Switch1(config)# access-list 10 permit ip host
D.Switch1(config-if)# switchport port-security violation shutdown
E.Switch1(config-if)# ip access-group 10
A.copier
B.microwave oven
C.toaster
D.cordless phone
E.IP phone
F.AM radio
A.Switch1 - Fa 0/2
B.Switch1 - Fa 0/9
C.Switch2 - Fa 0/3
D.Switch2 - Fa 0/4
E.Switch2 - Fa 0/8
F.Router - Fa 1/0
A.If RIPv2 is the routing protocol, only the path AD will be installed in the routing table by default.
B.If RIPv2 is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.
C.If EIGRP is the routing protocol, only the path AD will be installed in the routing table by default.
D.If EIGRP is the routing protocol, the equal cost paths ABD and ACD will be installed in the routing table by default.
E.If EIGRP and OSPF are both running on the network, the EIGRP paths will be installed in the routing table.
F.If EIGRP and OSPF are both running on the network, the OSPF paths will be installed in the routing table.
A.addresses chosen by a company to communicate with the Internet
B.addresses that cannot be routed through the public Internet
C.addresses that can be routed through the public Internet
D.a scheme to conserve public addresses
E.addresses licensed to enterprises or ISPs by an Internet registry organization
最新試題
在Cisco IOS 設備中，啟動配置文件存儲于何處？（）
請參見圖示。一臺路由器（其路由表如圖所示）收到發往192.168.1.4的數據包。路由器將如何處理該數據包？（）
請參見圖示。哪種邏輯拓?fù)涫菍D示網絡的準確描述？（）
請參見圖示。網絡中的所有設備均使用默認配置。此拓?fù)渲写嬖诙嗌賯€(gè)廣播域？（）
請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述，哪兩項是正確的？（）
請參見圖示。一臺主機正使用NAT 連接到Internet。下列哪三項IP 地址可實現此連接？（）
請參見圖示。圖中所示路由表所屬的PC 已正確配置。IP 地址192.168.1.254屬于哪一個網絡設備或接口？（）
以下哪兩種介質可提供高達1Gb/s 的帶寬？（）
請參見圖示。主機A 正在訪問多臺服務器。結合使用什么端口號和地址即可唯一識別特定服務器上運行的特定進程？（）
請參見圖示。主機X 和主機Y 與本地網絡的通信受到限制。此問題的原因是什么？（）