A.reduces routing table entries
B.auto-negotiation of media rates
C.efficient utilization of MAC addresses
D.dedicated communications between devices
E.ease of management and troubleshooting
您可能感興趣的試卷
你可能感興趣的試題
A.remote DLCI on the main interface
B.local DLCI on the main interface
C.local DLCI on the subinterface
D.remote DLCI on the subinterface
A.Set the IP gateway to be used by the network.
B.Perform host discovery used DHCPDISCOVER message.
C.Configure IP address parameters from DHCP server to a host.
D.Provide an easy management of layer 3 devices.
E.Monitor IP performance using the DHCP server.
F.Assign and renew IP address from the default pool.
A.Itsendsdataincleartextformat.
B.ItisnolongersupportedonCisconetworkdevices.
C.ItismoresecurethanSSH
D.Itrequiresanenterpriselicenseinordertobeimplemented.
E.ItrequiresthatthedestinationdevicebeconfiguredtosupportTelnetconnections.
Refer to the exibit. Three cisco 2950 switches are set to their default priority settings.During the spanning-tree process,which switch will be elected as the root bridge?()
A.Switch3
B.Switch4
C.Switch2
D.Switch1
A.6,9,12,18
B.1,2,5.5,6
C.5.5,6,9,11
D.1,2,5.5,11
A.learning
B.listening
C.discarding
D.forwarding
The following configuration line was added to router R1
Access-list 101 permit ip 10.25.30.00.0.0.255 any
What is the effect of this access list configuration?()
A.ermit all packets matching the first three octets of the source address to all destinations
B.permit all packet matching the last octet of the destination address and accept all source addresses
C.permit all packet matching the host bits in the source address to all destinations
D.permit all packet from the third subnet of the network address to all destinations
A.172.16.16.0
B.176.24.0.0
C.172.16.0.0
D.172.16.28.0
A.server
B.client
C.tunnel
D.transparent
A.traceroute address
B.tracert address
C.ssh address
D.telnet address
最新試題
請參見圖示。從主機X 發出的到主機Y 的tracert 命令已成功。下列哪一項正確地反映了追蹤列表中顯示的中間網絡設備的順序?()
OSI 模型的哪兩項功能在第2層實現?()
要將數據包發送到遠程網絡,應使用哪種設備?()
請參見圖示。哪種邏輯拓撲是對圖示網絡的準確描述?()
請參見圖示。網絡中的所有設備均使用默認配置。此拓撲中需要多少個邏輯地址范圍?()
請參見圖示。主機A 正在訪問多臺服務器。結合使用什么端口號和地址即可唯一識別特定服務器上運行的特定進程?()
請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是,從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題?()
請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()
請參見圖示。主機A 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,路由器Y 的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為172.16.1.5而目的IP 地址為172.16.7.24的數據包。捕獲該幀時,它的源MAC 地址是什么?()
何時必須使用clock rate 命令配置路由器串行接口?()