A.ermit all packets matching the first three octets of the source address to all destinations
B.permit all packet matching the last octet of the destination address and accept all source addresses
C.permit all packet matching the host bits in the source address to all destinations
D.permit all packet from the third subnet of the network address to all destinations

A.172.16.16.0
B.176.24.0.0
C.172.16.0.0
D.172.16.28.0

A.server
B.client
C.tunnel
D.transparent

A.traceroute address
B.tracert address
C.ssh address
D.telnet address

A.Switches take less time to process frames than hubs take.
B.Switches do not forward broadcasts.
C.Hubs can filter frames.
D.Using hubs can increase the amount of bandwidth available to hosts.
E.Switches increase the number of collision domains in the network.

A.show mac-address
B.show arp
C.show table
D.show switchport

A.a dynamic routing procotol on InternetRouter to advertise summarized routers to CentralRouter.
B.a dynamic routing procotol on CentralRouter to advertise summarized routers to InternetRouter.
C.a static route on InternetRouter to direct traffic that is destined for 172.16.0.0/16 to CentralRouter.
D.a dynamic routing procotol on InternetRouter to advertise all routes to CentralRouer.
E.a dynamic routing procotol on CentralRouer to advertise all routes to InternetRouter
F.a static，default route on CentralRouter that directs traffic to InternetRouter.

A.show command
B.debug command
C.configuration command
D.rommon command

A.A successor route is used by EIGRP to forward traffic to a destination.
B.Successor routes are saved in the topology table to be used if the primary route fails.
C.Successor routes are flagged as "active" in the routing table.
D.A successor route may be backed up by a feasible successor route.
E.Successor routes are stored in the neighbor table following the discovery process.

A.one
B.three
C.two
D.zero