A.remote DLCI on the main interface
B.local DLCI on the main interface
C.local DLCI on the subinterface
D.remote DLCI on the subinterface
您可能感興趣的試卷
你可能感興趣的試題
A.Set the IP gateway to be used by the network.
B.Perform host discovery used DHCPDISCOVER message.
C.Configure IP address parameters from DHCP server to a host.
D.Provide an easy management of layer 3 devices.
E.Monitor IP performance using the DHCP server.
F.Assign and renew IP address from the default pool.
A.Itsendsdataincleartextformat.
B.ItisnolongersupportedonCisconetworkdevices.
C.ItismoresecurethanSSH
D.Itrequiresanenterpriselicenseinordertobeimplemented.
E.ItrequiresthatthedestinationdevicebeconfiguredtosupportTelnetconnections.
Refer to the exibit. Three cisco 2950 switches are set to their default priority settings.During the spanning-tree process,which switch will be elected as the root bridge?()
A.Switch3
B.Switch4
C.Switch2
D.Switch1
A.6,9,12,18
B.1,2,5.5,6
C.5.5,6,9,11
D.1,2,5.5,11
A.learning
B.listening
C.discarding
D.forwarding
The following configuration line was added to router R1
Access-list 101 permit ip 10.25.30.00.0.0.255 any
What is the effect of this access list configuration?()
A.ermit all packets matching the first three octets of the source address to all destinations
B.permit all packet matching the last octet of the destination address and accept all source addresses
C.permit all packet matching the host bits in the source address to all destinations
D.permit all packet from the third subnet of the network address to all destinations
A.172.16.16.0
B.176.24.0.0
C.172.16.0.0
D.172.16.28.0
A.server
B.client
C.tunnel
D.transparent
A.traceroute address
B.tracert address
C.ssh address
D.telnet address
A.Switches take less time to process frames than hubs take.
B.Switches do not forward broadcasts.
C.Hubs can filter frames.
D.Using hubs can increase the amount of bandwidth available to hosts.
E.Switches increase the number of collision domains in the network.
最新試題
請參見圖示。一臺路由器(其路由表如圖所示)收到發往192.168.1.4的數據包。路由器將如何處理該數據包?()
OSI 模型的哪兩項功能在第2層實現?()
在配置路由器時,網絡技術人員想要命名路由器。輸入hostname 命令后,技術人員會看到下列哪一項提示?()
請參見圖示。當計算機A 向計算機D 發送幀時,哪些計算機會接收該幀?()
請參見圖示。對于從主機A 向Web 服務器發出的網頁請求,正確的目的套接字數字是什么?()
請參見圖示。某用戶想要查看當前的配置。圖中所示為ipconfig/all 命令的輸出。從此輸出可以得到哪三項結論?()
請參見圖示。主機A 正在訪問多臺服務器。結合使用什么端口號和地址即可唯一識別特定服務器上運行的特定進程?()
請參見圖示。網絡中的主機A 正在向主機B 發送數據段。有關所交換的數據段的流量控制如圖所示。下列關于此通信的陳述,哪兩項是正確的?()
請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()
請參見圖示。主機A 和B 無法互相通信。此問題的原因是什么?()