During the installation of the Cisco WCS version 4.0， an error occurs.
Where would you look for theinstallation log， in order to learn more about this error？（）
A.at the root of the installation drive
B.in the Cisco WCS installation directory
C.on the desktop of the server
D.in the Cisco WCS\Logs directory
您可能感興趣的試卷
你可能感興趣的試題
You are configuring an RF group of controllers that coordinate Radio Resource Managementcalculations.
What is the maximum number of WLAN controllers that you can add？（）
A.17
B.20
C.12
D.24
A.Multicast on
B.Aggressive Load Balancing off
C. Multicast off
D.AP Fallback on
E.Aggressive Load Balancing on
F.AP Fallback off
You are installing a Cisco 4402 Series Wireless LAN Controller.
Which type of interface should you use on the controller’s distribution port？（）
A.1000BASE-SX SFP
B.10/100/1000 Mbps RJ45
C.10/100 Mbps RJ45
D.10000BASE-SX
By default， on the WLAN controller for a voice application using Cisco 7921 wireless IP phones.
What is the percentage of RF bandwidth that can be dedicated to the phones？（）
A.75 percent
B.85 percent
C.56 percent
D.55 percent
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware. Before you press and hold the MODEbutton.
You should verify that the file name is which of the following？（）
A. c1130-k9w7-tar.boot
B. c1130-k9w7-tar.123-7.JA1.tar
C. c1130-k9w7-tar.default
D. c1130-k9w7-tar.recove
A.Problem Management
B.Configuration Management
C.Incident Management
D.Change Management
A.15
B.10
C.1
D.5
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.
Which message would best describe the establishment of the tunnel from the foreign controller’sperspective？（）
A.Received Mobile Anchor Export message
B.Transmit Plumbing duplex mobility tunnel message
C.Received Plumbing duplex mobility tunnel message
D.Transmit Mobile Anchor Export message
You are charged with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients. In addition to implementing PSPF or peer-to-peer blocking on the wireless side.
Which of the following actions should you perform on the wired infrastructure？（）
A.Implement a Cisco Secure IPS sensor.
B.Implement 802.1X on the switch ports.
C.Take no action， you have achieved your goal.
D.Implement a protected port on the access switches.
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication.
Inorder to accomplish this， which two IETF RADIUS attributes should you configure on the Cisco Secure ACS？（）
A.083 Tunnel-Preference
B.066 Tunnel-Client-Endpoint
C.064 Tunnel-Type
D.082 Tunnel-Assignment-ID
E.081 Tunnel-Private-Group-ID
F.067 Tunnel-Server-Endpoint
最新試題
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast？（）
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror." Which failure could produce this error？（）
If it is properly deployed， a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu onthe controller？（）
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）