A.Multiple controller-based access points will load-balance the containment task using fewer resources than a single access point.
B.Clients connected to the rogue access point may be out of the range of the controller-based access point providing containment.
C.Each controller-based access point can handle only a limited amount of clients connected to the rogue access points.
D.Clients connected to the rogue access point must be able to connect to the containment controller-based access point.
您可能感興趣的試卷
你可能感興趣的試題
A.three
B.four
C.five
D.six
A.1
B.5
C.10
D.15
A.50
B.128
C.512
D.1024
In a deployment using standalone access points， clients set up to authenticate with EAP-PEAP or EAP-Cisco Wireless （Cisco-LEAP） cannot authenticate. When you inspect the Failed Attempts report on theCisco Secure ACS， you find this error： "Unknown network access server NAS."
Which problem may havecaused this failure？（）
A.misconfigured EAP type on the access point
B.misconfigured EAP type on the AAA server
C.misconfigured IP address of the access point on the AAA server
D.misconfigured IP address of the AAA server on the access point
You are configuring a wireless LAN controller for QoS.
Which 802.11e user priority tag should you apply tovoice applications？（）
A.1
B.3
C.4
D.6
A.MS-CHAP v2
B.PAP
C.GTC
D.MD5
A.Wireless Control System
B.wireless clients
C.wireless controllers
D.controller-based access points
E.Location Appliance
A.4
B.8
C.16
D.32
A.Set Data Beacon Rate
B.Set Infrastructure SSID
C.Enable IP redirection on this SSID
D.Multiple BSSID
E.Force Infrastructure Devices to associate only to this SSID
A.Cisco-LEAP， EAP-FAST， EAP-PEAP （GTC）， EAP-TLS
B.Cisco-LEAP， EAP-MD5， EAP-PEAP （GTC）， EAP-TTLS
C.Cisco-LEAP， EAP-PSK， EAP-PEAP （MS-CHAP v2）， EAP-TLS
D.Cisco-LEAP， EAP-FAST， EAP-PEAP （MS-CHAP v2）， EAP-TTLS
最新試題
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped.What may cause this problem？（）
On a WLAN controller， what is the default roaming bandwidth percentage reserved for voice clients？（）
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor，4GB RAM， and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）