You are configuring an rf group of controllers that coordinate radio resource management calculations.
What is the maximum number of wlan controllers that you can add？（）
A.17
B.20
C.12
D.24
您可能感興趣的試卷
你可能感興趣的試題
When configuring a wlan controller for a voice application using cisco 7920 wireless ip phones.
which two general control settings should you select？（）
A.multicast on
B.aggressive load balancing off
C.multicast off
D.ap fallback on
E.aggressive load balancing on
F.ap fallback off
You are installing a cisco 4402 series wireless lan controller.
Which type of interface should you use on the controller’s distribution port？（）
A.1000base-sx sfp
B.10/100/1000 mbps rj45
C.10/100 mbps rj45
D.10000base-sx
By default，on the wlan controller for a voice application using cisco 7921 wireless ip phones.
what is the percentage of rf bandwidth that can be dedicated to the phones？（）
A.75 percent
B.85 percent
C.56 percent
D.55 percent
A.clients connected to the rogue access point must be able to connect to the containment controller-based access point.
B.multiple controller-based access points will load-balance the containment task using fewer resources than a single access point.
C.clients connected to the rogue access point may be out of the range of the controller-based access point providing containment.
D.each controller-based access point can handle only a limited amount of clients connected to the rogue access points.
A.c1130-k9w7-tar.boot
B.c1130-k9w7-tar.123-7.ja1.tar
C.c1130-k9w7-tar.default
D.c1130-k9w7-tar.recover
A.problem management
B.configuration management
C.incident management
D.change management
A.technology assessment
B.operations assessment
C.security assessment
D.security administration
E.change management
A.15
B.10
C.1
D.5
A mobility group is created by a cisco wlcm and 4402 series wireless lan controller. A client that is anchored on the cisco wlcm roams to an access point on the 4402 controller. you then run a debug command on the 4402 controller.
Which message would best describe the establishment of the tunnel from the foreign controller’s perspective？（）
A.received mobile anchor export message
B.transmit plumbing duplex mobility tunnel message
C.received plumbing duplex mobility tunnel message
D.transmit mobile anchor export message
You are charged with implementing a secure wireless installation which will provide internet
access to client devices but will not allow communications between wireless clients.
In addition to implementing pspf or peer-to-peer blocking on the wireless side，which of the following actions should you perform on the wired infrastructure？（）
A.implement a cisco secure ips sensor.
B.implement 802.1x on the switch ports.
C.take no action， you have achieved your goal.
D.implement a protected port on the access switches.
最新試題
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem？（）
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
What is the maximum number of wireless controllers that the highest-end Cisco WCS server canmanage？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
A Cisco Wireless Location Appliance has been added to track RFID tags placed on laptops beingused in a school.Classrooms at the school have concrete block walls. During testing，you discoverthat the accuracy of the system needs to be improved.You decide to edit the map in the Cisco WCS to add the interior walls.How many interior walls can you add to improve the accuracy of thelocation appliance？（）
If it is properly deployed， a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu onthe controller？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter，the status LED and activity LED are alternating on and off.What does this indicate？（）
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem？（）