You suspect that a hacker may be performing a MAC address flooding attack somewhere within the network.
Which description correctly describes a MAC address flooding attack？（）
A.The attacking device spoofs a source MAC address of a valid host currently in the CAM table. The switch then forwards frames destined for the valid host to the attacking device.
B.Frames with unique， invalid destination MAC addresses flood the switch and exhaust CAM table space. The result is that new entries cannot be inserted because of the exhausted CAM table space， and traffic is subsequently flooded out all ports.
C.The attacking device crafts ARP replies intended for valid hosts. The MAC address of the attacking device then becomes the destination address found in the Layer 2 frames sent by the valid network device.
D.The attacking device crafts ARP replies intended for valid hosts. The MAC address of the attacking device then becomes the source address found in the Layer 2 frames sent by the valid network device.
E.The attacking device spoofs a destination MAC address of a valid host currently in the CAM table. The switch then forwards frames destined for the valid host to the attacking device.
F.Frames with unique， invalid source MAC addresses flood the switch and exhaust CAM table space. The result is that new entries cannot be inserted because of the exhausted CAM table space， and traffic is subsequently flooded out all ports.
G.None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
Study the exhibit shown below carefully.
In this scenario the service provider wants to ensure that switch S1 is the root switch for its own network and the network of .
On which interfaces should root guard be configured to ensure that this happens？（）
A.Interfaces 11 and 12
B.Interfaces 1， 2， 3， and 4
C.Interfaces 5 and 6
D.Interfaces 5， 6， 7， and 8
E.Interfaces 1 and 2
F.Interfaces 1， 3， 5， and 6
In order to enhance worker productivity， a Cisco wireless network has been implemented at all locations.
Which three statements regarding WLAN are true？（）
A.A WLAN client will operate in half-duplex mode.
B.The Aironet 1230 access point is an example of an access point that operates solely as a lightweight access point.
C.Ad hoc mode allows mobile clients to connect directly without an intermediate AP.
D.WLANs are designed to share the medium and can easily handle an increased demand of channel contention.
E.A lightweight AP receives control and configuration from a WLAN controller to which it is associated.
F.Another term for infrastructure mode is independent service set （IBSS）.
Switch 1 was configured as shown below：
Based on the output shown above，
which statement is true？ （）
A.IP traffic matching access list is forwarded through VLANs 5-10.
B.All VLAN traffic in VLANs 5-10 that match access list will be forwarded， and all else will be dropped.
C.IP traffic matching VLAN list 5-10 will be forwarded， and all other traffic will be dropped.
D.All VLAN traffic matching VLAN list 5-10 will be forwarded， and all traffic matching access list is dropped.
E.None of the other alternatives apply
A. QoS
B. call setup and teardown
C. call routing
D. call supervision
E. audio signal compression
A. device PoE requirements
B. device IP address
C. device voice VLAN ID
D. device platform
A. an edge port that transitions to the forwarding state
B. a non-edge port that transitions to the blocking state
C. a non-edge port that transitions to the forwarding state
D. an edge port that transitions to the blocking state
E. any port that transitions to the blocking state
F. any port that transitions to the forwarding state
A. active
B. speak
C. learn
D. listen
E. init
F. standby
You administer the network shown above. You issue the show interfaces trunk command on SwitchA and receive the following output：
SwitchA#show interfaces trunk
Port Mode Encapsulation Status Native vlan
Fa0/1 desirable -n802.1q trunking 1
Port Vlans allowed on trunk Fa0/1 1-4094
Port Vlans allowed and active in management domain
Fa0/1 1-9，31-37
Port Vlans in spanning tree forwarding state and not pruned
Fa0/1 1-9，31，33-37
Which of the following statements is true regarding VLAN 32？（）
A. VLAN 32 is not allowed on the trunk port.
B. VLAN 32 is not active on the switch.
C. Traffic from VLAN 32 is not being sent over the trunk port.
D. Traffic from VLAN 32 is not restricted to only the trunk ports that require it.
You want to configure a switched internetwork with multiple VLANs as shown above.
Which of the following commands should you issue on SwitchA for the port connected to SwitchB？ （）
A. switchport mode trunk
B. switchport access vlan 5
C. switchport mode access vlan 5
D. switchport trunk native vlan 5
Refer to the exhibit.
Which of the following should you do to configure the IP phone to override the priority of the data packets it receives from the host？ （）
A. Issue the mls qos trust cos command on the switch port connected to the IP phone.
B. Issue the switchport priority extend cos command on the switch port connected to the IP phone.
C. Issue the switchport priority extend cos command on the IP phone.
D. Issue the mls qos trust cos command on the IP phone.
最新試題
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals？（）
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this？（）
Refer to the exhibit. STP has been implemented in the network. Switch SW_A is the root switch for the default VLAN. To reduce the broadcast domain， the network administrator decides to split users on the network into VLAN 2 and VLAN 10. The administrator issues the command spanning-tree vlan 2 root primary on switch SW_A. What will happen as a result of this change？（）
Which statement is correct about RSTP port roles？（）
Refer to the exhibit. What will happen when one more user is connected to interface FastEthernet 5/1？ （）
During routine maintenance， it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time， DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ？ （）
Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both have had the command spanning-tree mode rapid-pvst issued on them. What will be the result？（）
During routine maintenance， G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However， after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ？ （）
What must be the same to make multiple switches part of the same Multiple Spanning Tree （MST）？（）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）