Study the exhibit shown below carefully.
In this scenario the service provider wants to ensure that switch S1 is the root switch for its own network and the network of .
On which interfaces should root guard be configured to ensure that this happens?()
A.Interfaces 11 and 12
B.Interfaces 1, 2, 3, and 4
C.Interfaces 5 and 6
D.Interfaces 5, 6, 7, and 8
E.Interfaces 1 and 2
F.Interfaces 1, 3, 5, and 6
您可能感興趣的試卷
你可能感興趣的試題
In order to enhance worker productivity, a Cisco wireless network has been implemented at all locations.
Which three statements regarding WLAN are true?()
A.A WLAN client will operate in half-duplex mode.
B.The Aironet 1230 access point is an example of an access point that operates solely as a lightweight access point.
C.Ad hoc mode allows mobile clients to connect directly without an intermediate AP.
D.WLANs are designed to share the medium and can easily handle an increased demand of channel contention.
E.A lightweight AP receives control and configuration from a WLAN controller to which it is associated.
F.Another term for infrastructure mode is independent service set (IBSS).
Switch 1 was configured as shown below:
Based on the output shown above,
which statement is true? ()
A.IP traffic matching access list is forwarded through VLANs 5-10.
B.All VLAN traffic in VLANs 5-10 that match access list will be forwarded, and all else will be dropped.
C.IP traffic matching VLAN list 5-10 will be forwarded, and all other traffic will be dropped.
D.All VLAN traffic matching VLAN list 5-10 will be forwarded, and all traffic matching access list is dropped.
E.None of the other alternatives apply
A. QoS
B. call setup and teardown
C. call routing
D. call supervision
E. audio signal compression
A. device PoE requirements
B. device IP address
C. device voice VLAN ID
D. device platform
A. an edge port that transitions to the forwarding state
B. a non-edge port that transitions to the blocking state
C. a non-edge port that transitions to the forwarding state
D. an edge port that transitions to the blocking state
E. any port that transitions to the blocking state
F. any port that transitions to the forwarding state
A. active
B. speak
C. learn
D. listen
E. init
F. standby
You administer the network shown above. You issue the show interfaces trunk command on SwitchA and receive the following output:
SwitchA#show interfaces trunk
Port Mode Encapsulation Status Native vlan
Fa0/1 desirable -n802.1q trunking 1
Port Vlans allowed on trunk Fa0/1 1-4094
Port Vlans allowed and active in management domain
Fa0/1 1-9,31-37
Port Vlans in spanning tree forwarding state and not pruned
Fa0/1 1-9,31,33-37
Which of the following statements is true regarding VLAN 32?()
A. VLAN 32 is not allowed on the trunk port.
B. VLAN 32 is not active on the switch.
C. Traffic from VLAN 32 is not being sent over the trunk port.
D. Traffic from VLAN 32 is not restricted to only the trunk ports that require it.
You want to configure a switched internetwork with multiple VLANs as shown above.
Which of the following commands should you issue on SwitchA for the port connected to SwitchB? ()
A. switchport mode trunk
B. switchport access vlan 5
C. switchport mode access vlan 5
D. switchport trunk native vlan 5
Refer to the exhibit.
Which of the following should you do to configure the IP phone to override the priority of the data packets it receives from the host? ()
A. Issue the mls qos trust cos command on the switch port connected to the IP phone.
B. Issue the switchport priority extend cos command on the switch port connected to the IP phone.
C. Issue the switchport priority extend cos command on the IP phone.
D. Issue the mls qos trust cos command on the IP phone.
You administer a network that uses two routers, R1 and R2, configured as an HSRP group to provide redundancy for the gateway. Router R1 is the active router and has been configured as follows:
R1#configure terminal
R1(config)#interface fa0/0
R1(config-if)#ip address 10.10.0.5 255.255.255.0
R1(config-if)#standby 1 priority 150
R1(config-if)#standby preempt delay minimum 50
R1(config-if)#standby 1 track interface fa0/2 15
R1(config-if)#standby 1 ip 10.10.0.20
Which of the following describes the effect the standby preempt delay minimum 50 command will have on router R1?()
A. The HSRP priority for router R1 will increase to 200.
B. Router R1 will become the standby router if the priority drops below 50.
C. The HSRP priority for router R1 will decrease to 50 points when Fa0/2 goes down.
D. Router R1 will wait 50 seconds before attempting to preempt the active router.
最新試題
Refer to the exhibit. What will happen when one more user is connected to interface FastEthernet 5/1? ()
Refer to the exhibit. What does the command channel-group 1 mode desirable do? ()
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals?()
Refer to the exhibit. Based on the output of the show spanning-tree command, which statement is true? ()
Which two statements about the various implementations of STP are true?()
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this?()
Which option correctly identifies the Cisco IOS switching methods in descending order from the fastest method to the slowest method?()
Which three statements about STP timers are true?()
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2?()
If G1/0/1 on DS1 is shutdown, what will be the current priority value of the Vlan105’s group on DS1 ?()