A.127.0.0.1
B.172.16.0.1
C.192.168.0.5
D.223.0.0.1
E.224.0.0.5
F.254.255.255.255
您可能感興趣的試卷
你可能感興趣的試題
A.205.7.8.32/27
B.191.168.10.2/23
C.127.0.0.1
D.224.0.0.10
E.203.123.45.47/28
F.10.10.0.0/13
A. VTP
B. ISL
C. CDP
D. 802.1Q
E. 802.1p
F. LLC
A. All switch and bridge ports are in the forwarding state.
B. All switch and bridge ports are assigned as either root or designated ports.
C. All switch and bridge ports are in either the forwarding or blocking state.
D. All switch and bridge ports are either blocking or looping.
A. to make VTP easier to implement
B. to isolate broadcast traffic
C. to increase the size of the collision domain
D. to allow more devices to connect to the network
E. to logically group hosts according to function
F. to increase network security
A. Install anti-virus software on the student computers.
B. Put the faculty computers in a separate VLAN.
C. Power down the switches that connect to faculty computers when they are not in use.
D. Remove the student computers from the network and put them on a peer-to-peer network.
E. Create an access list that blocks the students from the Internet where the hacking tolls are located.
A. VTP allows routing between VLANs.
B. VTP allows a single switch port to carry information to more than one VLAN.
C. VTP allows physically redundant links while preventing switching loops.
D. VTP simplifies switch administration by allowing switches to automatically share VLAN configuration information.
E. VTP helps to limit configuration errors by keeping VLAN naming consistent across the VTP domain.
F. VTP enhances security by preventing unauthorized hosts from connecting to the VTP domain.
A. TestKing1(config-if)# switchport port-security maximum 1
B. TestKing1(config)# mac-address-table secure
C. TestKing1(config)# access-list 10 permit ip host
D. TestKing1(config-if)# switchport port-security violation shutdown
E. TestKing1(config-if)# ip access-group 10
A.NCP
B.ISDN
C.SLIP
D.LCP
E.DLCI
A. ARP
B. CDP
C. DHCP
D. DNS
E. ICMP
A. to prevent routing loops
B. to create a default route
C. to provide multiple gateways for hosts
D. to maintain a loop-free Layer 2 network topology
E. to enhance the functions of SNMP
最新試題
Which connections allow the use of full-duplex Ethernet?()
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? ()
A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? ()
Five minutes after issuing the show running-config command, a technician enters the command again and notices that several access list statements have been altered. Because of this, the technician believes that the router is being configured by an unknown person through Telnet. Before changing the router passwords, the technician would like to discover if anyone is connected to the router by Telnet and stop them from making further changes.Which commands will accomplish these options?()
Which of the following options lists the steps in PPP session establishment in the correct order?()
The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses.What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum? ()
Which command is used to display the placement and direction of an IP access control list on a router?()
Which of the following describe router functions?()
New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? ()
What is the purpose of typing o/r 0x2142 during a password recover procedure on a 2500 series router?()