A. Neighbor table
B. SPF table
C. RTP table
D. Topology table
E. Query table
F. DUAL table
您可能感興趣的試卷
你可能感興趣的試題
A. The use of discontiguous subnets is not allowed
B. The use of variable length subnet masks is permitted
C. RIP v1 is a classless routing protocol
D. IGRP supports classless routing within the same autonomous system
E. RIP v2 supports classless routing
A. A successor route is used by EIGRP to forward traffic to destination.
B. Successor routes are saved in the topology table to be used if the primary route fails.
C. Successor routes are flagged as "active" in the routing table.
D. A successor route may be backed up by a feasible successor route.
E. Successor routes are stored in the neighbor table following the discovery process.
A. In the routing table only.
B. In the neighbor table only.
C. In the topology table only.
D. In the routing table and neighbor table.
E. In the routing table and topology table.
F. In the topology table and neighbor table.
A. point-to-point
B. Backbone area 0
C. Broadcast multicast
D. Non-broadcast multi-access
E. The DR/BDR process is done for all interface types
A. The update information will be added to the existing routing table.
B. The update information will replace the existing routing table entry.
C. The update will be ignored and thus no further action will occur.
D. The existing routing table entry will be purged from the routing table and all routers will attempt convergence.
A.90
B.100
C.110
D.120
E.130
F.170
G.200
A RIP router has an entry in the routing table for a specific network destination. It then gets updated with another entry for that same destination, but with a higher path cost (hop count) than the one already in the routing table.
What will the router do in this situation?()
A. It will ignore the update and take no further action.
B. It will add the update information to its routing table.
C. It will replace the existing routing table entry with the update information.
D. It will delete the existing routing table and will send out hello packets to rebuild the routing table.
The Testking network is utilizing RIP as the IP routing protocol. Router TK1 learns how to reach the same destination via 6 different paths. All paths have the same metric and administrative distance.
With all routers using the default operation,which of the paths will be chosen to reach the destination?()
A. Only the first two paths that are learned.
B. Four of the paths.
C. All six routes in a routed robin fashion.
D. The oldest two paths in the routing table.
E. The first path learned to the destination network.
A. Discontiguous subnets are not allowed.
B. Variable length subnet masks are allowed.
C. RIP v1 is a classless routing protocol.
D. IGRP supports classless routing within the same autonomous system.
E. RIP v2 supports classless routing.
A. Only routers can split boundaries (horizons) between concentric networks.
B. Each AS must keep routing tables converged to prevent dead routes from being advertised across boundaries.
C. Networks can only remain fully converged if all information is sent out all active interfaces.
D. Information about a route should not be sent back in the direction from which the original update came.
E. Distance vector protocols need fall back routers that are responsible for momentary loops.
最新試題
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? ()
Which statement describes the rule of split horizon?()
Given a subnet mask of 255.255.255.224, which of the following addresses can be assigned to network hosts?()
Which of the following describe router functions?()
The network 172.12.0.0 needs to be divided into subnets where each subnet has the capacity of 458 IP addresses.What would be the correct subnet mask to accomplish this division keeping the number of subnets at the maximum? ()
Identify three valid host addresses in the 192.168.27.0 network with a subnet mask of 255.255.255.240. ()
Which command is required for connectivity in a Frame Relay network if Inverse ARP is not operational? ()
Which characteristics are representative of a link-state routing protocol?()
Which command is used to display the placement and direction of an IP access control list on a router?()
A router with a serial interface will be used for an ISDN link.What other function group devices are required to complete the connection to the service provider? ()