A.100 meters
B.100 feet
C.100 yards
D.200 meters

A. 10 Mbps
B. 11 Mbps
C. 54 Mbps
D. 100 Mbps
E. none of the above

A. IEEE 802.3
B. IEEE 802.5
C. IEEE 802.11h
D. IEEE 802.11c
E. IEEE 802.11

A. Broadband personal comm. Service (PCS)
B. Broadband circuit
C. Infrared
D. Spread spectrum
E. Cable

A. Half-duplex Ethernet operates in a shared collision domain.
B. Half-duplex Ethernet operates in an exclusive broadcast domain.
C. Half-duplex Ethernet has efficient throughput.
D. Half-duplex Ethernet has lower effective throughput.
E. Half-duplex Ethernet operates in an exclusive collision domain.

A. Half-duplex Ethernet operates in a shared collision domain.
B. Full-duplex Ethernet has a lower effective throughput.
C. Half-duplex Ethernet operates in a private collision domain.
D. Full-duplex Ethernet allows two-way communication.
E. Half-duplex Ethernet operates in a private broadcast domain.

A. It uses inexpensive hubs
B. It operates without collisions
C. It operates on switches
D. It provides faster data transfer
E. It utilizes fewer wiring pairs

A. Full-duplex Ethernet uses CSMA/CD to prevent collisions.
B. Half-duplex Ethernet uses a loopback circuit to detect collisions.
C. A full-duplex Ethernet card allows 20Mbps for data transmission.
D. Full-duplex Ethernet makes use of two pairs of wires for data.
E. An Ethernet hub can operate both half and full duplex simultaneously.

A. The destination host sends a request to the source for retransmission.
B. The jam signal indicates that the collision has been cleared.
C. The hosts will attempt to resume transmission after a time delay has expired.
D. An electrical pulse indicates that the collision has cleared.
E. The router on the segment will signal that the collision has cleared.
F. The hosts will do nothing, as the higher layers are responsible for data error correction and re-transmission.

A. 802.11
B. 802.5
C. 802.3ab
D. 802.3ae
E. 802.3z
F. 802.3u