A. Broadband personal comm. Service (PCS)
B. Broadband circuit
C. Infrared
D. Spread spectrum
E. Cable
您可能感興趣的試卷
你可能感興趣的試題
A. Half-duplex Ethernet operates in a shared collision domain.
B. Half-duplex Ethernet operates in an exclusive broadcast domain.
C. Half-duplex Ethernet has efficient throughput.
D. Half-duplex Ethernet has lower effective throughput.
E. Half-duplex Ethernet operates in an exclusive collision domain.
A. Half-duplex Ethernet operates in a shared collision domain.
B. Full-duplex Ethernet has a lower effective throughput.
C. Half-duplex Ethernet operates in a private collision domain.
D. Full-duplex Ethernet allows two-way communication.
E. Half-duplex Ethernet operates in a private broadcast domain.
A. It uses inexpensive hubs
B. It operates without collisions
C. It operates on switches
D. It provides faster data transfer
E. It utilizes fewer wiring pairs
A. Full-duplex Ethernet uses CSMA/CD to prevent collisions.
B. Half-duplex Ethernet uses a loopback circuit to detect collisions.
C. A full-duplex Ethernet card allows 20Mbps for data transmission.
D. Full-duplex Ethernet makes use of two pairs of wires for data.
E. An Ethernet hub can operate both half and full duplex simultaneously.
A. The destination host sends a request to the source for retransmission.
B. The jam signal indicates that the collision has been cleared.
C. The hosts will attempt to resume transmission after a time delay has expired.
D. An electrical pulse indicates that the collision has cleared.
E. The router on the segment will signal that the collision has cleared.
F. The hosts will do nothing, as the higher layers are responsible for data error correction and re-transmission.
A. 802.11
B. 802.5
C. 802.3ab
D. 802.3ae
E. 802.3z
F. 802.3u
A. Too many hosts in a broadcast domain
B. Full duplex operation
C. Broadcast storms
D. Multicasting
E. Segmentation
F. Low bandwidth
A. The use of Full-Duplex Mode.
B. The Creation on New Collision Domains.
C. The Creation on New Broadcast Domains.
D. The Addition of Hubs to the Network.
E. The use of switches in the Network.
F. The Amount of ARP or IPX SAP Traffic.
A. Increasing the number of collision domains.
B. Micro-segmenting the network.
C. Adding hubs for connectivity to the network.
D. Putting additional switches in the network.
E. Implementing VLANs in the network.
A. Blocking
B. Listening
C. Forwarding
D. Learning
E. Relaying
最新試題
Which Frame Relay feature is responsible for transmitting keepalives to ensure that the PVC does not shut down because of inactivity?（）
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? （）
Identify three valid host addresses in the 192.168.27.0 network with a subnet mask of 255.255.255.240. （）
Which of the following describe router functions?（）
Which of the following contribute to congestion on an Ethernet network?（）
Which command is used to display the placement and direction of an IP access control list on a router?（）
A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? （）
Which of the following correctly describe steps in the OSI data encapsulation process?（）
What feature of a networks switch allows an administrative to create separate broadcast domains?（）
What is the purpose of typing o/r 0x2142 during a password recover procedure on a 2500 series router?（）