A. Each end of the trunk line must be set to IEEE 802.1E encapsulation.
B. The VTP management domain name of both switches must be set the same.
C. All ports on both the switches must be set as access port.
D. One of the two switches must be configured as a VTP server.
E. A rollover cable is required to connect the two switches together.
F. A router must be used to forward VTP traffic between VLANs.
您可能感興趣的試卷
你可能感興趣的試題
A. Ping
B. Tracert
C. Ipconfig
D. Show ip route
E. Winipcfg
F. Show interfaces
A. ping
B. tracert
C. ipconfig
D. show ip route
E. winipcfg
F. show interfaces
G. All of the above
A. ping
B. tracert
C. netstat
D. show cdp neighbors detail
E. show ip route
F. traceroute
A. The switch port link lights will be off on both switches indicating the ports are not connected.
B. The switch port link light will be off on one switch indicating that STP has disabled the port.
C. The switch port link lights will flash amber indicating an error.
D. The switch port link lights will be green indicating normal operation.
A. show ip route
B. ipconfig
C. tracert
D. show interfaces
E. traceroute
F. ping
G. All of the above
Study the Exhibit below carefully:
London#show vtp
VTP Version: 2
Configuration Revision: 0
Maximum VLANs supported locally: 64
Number of existing VLANs: 5
VTP Operating Mode: Client
VTP Domain Name: London
VTP Pruning Mode: Disabled
VTP V2 Mode: Disabled
VTP Traps Generation: Disabled
Based on the information given above, what is the VTP function of this particular switch?（）
A. Learn and save VTP configuration in the running configuration.
B. Create and change VLANs.
C. Forwards information about VTP configuration.
D. VTP is disabled on this device.
E. VTP is not saved to NVRAM.
You are a senior network administrator at TestKing and your trusty junior administrator tells you that he failed his task of adding VLAN 50 to a Catalyst switch in the network. You enter in the 'show vtp status' command and get this output:
TK2# show vtp status
VTP Version :2
Configuration Revision :7
Maximum VLANs supported local :68
Number of existing VLANs :8
VTP Operating Mode :Client
VTP Domain Name :corp
VTP Pruning Mode :Disabled
VTP V2 Mode :Disabled
VTP Traps Generation :Disabled
MD5 digest :0x22 0xF3 0x1A
Configuration last modified by 172.18.22.15 at 5-28-03 1t:53:20
What commands must be issued on this switch to add VLAN 50 to the database?（）
A. TK2(config-if)# switchport access vlan 50
B. TK2(vlan)# vtp server
C. TK2(config)# config-revision 20
D. TK2(config)# vlan 50 name Tech
E. TK2(vlan)# vlan 50
F. TK2(vlan)# switchport trunk vlan 50
There are 2 switches in the Testking LAN, with no routers. Ports 1, 2 & 3 are assigned to VLAN 1 in switch 1 and 2 and ports 4, 5 & 6 are assigned to VLAN 2 in both switches. These two switches are connected together via a trunked link.
Which of the conditions below would verify trunk and VLAN operation?（）
A. Host 1 on VLAN 1 can ping Host 2 on VLAN 1
B. Host 1 on VLAN 1 can ping Host 4 on VLAN 2
C. Host 1 on VLAN 1 can not ping Host 2 on VLAN 1
D. Host 4 on VLAN 2 can not ping Host 1 on VLAN 1
E. Host 4 on VLAN 2 can ping Host 2 on VLAN 2
A TestKing.com technician is troubleshooting connectivity problems between two routers that are directly connected through the serial line. The technician notices that the serial line is up but cannot see any neighbors displayed in the output of the show cdp neighbors command.
In which OSI layer is the problem most likely occurring?（）
A. Physical
B. Data link
C. Network layer
D. Transport layer
E. Application layer
A.Application
B.Presentation
C.Session
D.Transport
E.Network
F.Data-Link
最新試題
What is the purpose of typing o/r 0x2142 during a password recover procedure on a 2500 series router?（）
An administrator would like to configure a switch over a virtual terminal connection from locations outside of the local LAN. Which of the following are required in order for the switch to be configured from a remote location? （）
What is the subnetwork address for a host with IP address 201.100.5.68/28?（）
New switches have been purchased for a network upgrade. The objective for the network design emphasizes efficient, error-free transport instead of fast transport.Which switching mode should be configured on the new switches to provide error-free transport to the network? （）
A technician at TestKing needs to update the network documentation. One of the tasks includes documenting the name of the IOS image file of each router in the network.Which commands could be used to find this information?（）
TestKing.com has allocated the IP add 199.144.27.0 is its network, to provide flexibility for the LAN design, a subnet mask of 255.255.255.240 has been chosen. Which of the following address can be assigned to LAN on the resulting subnets.（）
What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? （）
All WAN links is side the TestKing.com network use PPP with for authentication security. Which command will display the CHAP authentication process as it occurs between two routers in the network?（）
What is a global command?（）
Which connections allow the use of full-duplex Ethernet?（）