A. Application
B. Presentation
C. Session
D. Transport
E. Internet
F. Data Link
G. Physical

A. The data link layer
B. The application layer
C. The access layer
D. The session layer
E. The network layer

A. show ip links
B. show cdp neighbor
C. show cdp neighbor detail
D. show ip clients
E. show ip route
F. None of the above

A. to identify valid numbers for incoming calls
B. to define the type of ISDN switch at the central office
C. to specify the list of outgoing phone numbers used by the router
D. to associate a dial configuration with a physical interface
E. to define interesting traffic that will enable the link

A. Router(config-if)# encapsulation frame-relay q933a
B. Router(config-if)# encapsulation frame-relay ansi
C. Router(config-if)# encapsulation frame-relay ietf
D. Router(config-if)# encapsulation frame-relay isl
E. None of the above

A. A successor route is used by EIGRP to forward traffic to a destination.
B. Successor routes are saved in the topology table to be used if the primary route fails.
C. Successor routes are flagged as "active" in the routing table.
D. A successor route may be backed up by a feasible successor route.
E. Successor routes are stored in the neighbor table following the discovery process.
F. Successors are not used in EIGRP.

A. Show interface lmi
B. Show frame-relay lmi
C. Show interface frame-relay
D. Debug frame-relay interface.

A. EIA/TIA
B. Q.932
C. Q.933A
D. IEEE
E. Cisco
F. Annex D

A.serialup
B.clock
C.clockrate
D.dcerate
E.dterate

A. Nothing. The router is already suitable.
B. A BRI WAN interface in the router.
C. An external NT1 to terminate the local loop.
D. A TA/NT1 device on the router.