A.RIP route 10.1.2.0/24
B.EIGRP route 10.1.2.0/24
C.RIP route 10.1.0.0/16
D.OSPF route 10.1.0.0/16
E.RIP route 10.0.0.0/16
F.OSPF route 10.1.2.0/24
您可能感興趣的試卷
你可能感興趣的試題
A.OSPF topology table
B.OSPF interface table
C.OSPF routing information base
D.OSPF link-state database
E.OSPF adjacency table
F.OSPF neighbor table
A.Problem report
B.Problem collaboration
C.Problem diagnosis
D.Problem resolution
E.Problem documentation
F.Probiem authentication
A.0000.0c70.ac22
B.0000.0c07.22ac
C.0000.0c07.acl6
D.0000.0c07.ac22
E.0000.0c70.cala
F.0000.0d22.ac07
A.Eliminate potential causes
B.Collect information
C.Document causes
D.Hypothesize underlying causes
E.Verif/ hypothesis
F.Examine collected information
A.The adjacency table is populated from a router’s ARP cache
B.CEF does not require the first packet of a data flow to be process switched
C.CEF maintains the Forward Information Base and the adjacency table
D.CEF can be enabled with the interface command ip cef
E.The FIB is populated from a router’s IP routing table
F.On most router platforms CEF is enabled by default
A.CEF switching is disabled on the switch
B.The source device and destination device are in different VLANs
C.The VLAN is excluded from the trunk
D.The host is connected to the switch through an IP phone
E.A faulty cable from host to switch or between switches
F.The trunking encapsulation type is inconsistent on the two ends of the link
A.Cisco Express Fonvarding
B.FIB switching
C.Cache switching
D.Optimized switching
E.Process switching
F.Fast switching
A.Fault management
B.Accounting management
C.Operations management
D.Performance management
E.Security management
F.Configuration management
A.sh ip route
B.sh ip cef 〈ip_address〉
C.sh adjacency 〈ip_address〉
D.sh ip route 〈ip_addres$〉
E.sh ip adjacency 〈/p_address〉
F.sh ip cef 〈mac_addrQss〉〈ip_address〉
A.The port must be put into forwarding state manually after root-inconsistent state has beencorrected
B.A Root Guard port receiving superior BPDU goes into a root-inconsistent state
C.A Root Guard port receiving inferior BPDU goes into a root-inconsistent state
D.While the port is in a root-inconsistent state no user data is sent across that port
E.The port returns to a forwarding state if inferior BPDUs stop
F.It should be applied to all switch ports
最新試題
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
As a network engineer， do you know for what purpose SDM uses Security Device Event Exchange（SDEE）？（）
Study the exhibit carefully.Routers A and B are customer routers. Routers 1， 2， 3 and 4 are provider routers. The routers areoperating with various IOS versions. Which frame mode MPLS configuration statement is true？（）
In computer security， AAA stands for authentication， authorization and accounting. Which optionabout the AAA authentication enable default group radius enable command is correct？（）
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed？（）
As a network engineer， study the exhibit carefully. Router Net is unable to establish an ADSLconnection with its provider. Which action would correct this problem？（）
Drag each element of the Cisco IOS Firewall Feature Set from the above and drop onto itsdescription on the below.
Which statement correctly describes IPsec VPN backup technology？（）
IPSec VPN is a widely-acknowledged solution for enterprise network. Which three IPsec VPNstatements are true？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）