A.Memory requirements are higher for shared distribution tree than for source distribution tree
B.Creates a tree from a central RP to all last-hop routers
C.Uses a rendezvous point
D.An optimal path is created between each source router and each last-hop router
E.Place (S,G) entry in each router’s multicast routing table
F.Place (*,G) entry in a router’s multicast routing to table
您可能感興趣的試卷
你可能感興趣的試題
A.Statically defined RP
B.Bootstrap Router
C.Auto-RP
D.RP Discovery Protocol (RDP)
E.RP Helios
F.RPARP(RARP)
A.it is not a valid NetFlow command
B.it is an SNMP command that exports 1500-byte packets to IP address 192.168.1.50
C.it is a NetFlov/ command that v/ill export 1500-byte packets to IP address 192.168.1.50
D.it is a NetFlov/ command that allows IP address 192.168.1.50 to send traffic to port 1500
E.It is a NetFlov/ command that v/ill specify that the NetFlov/ collector’s IP address is192.168.1.50 over UDP port 1500
F.It is an SNMP command that exports flows to destination address 1Q2.168.1.50 for packets upto an MTU of 1500
A.Following the traffic path
B.Top-down
C.Comparing configurations
D.Bottom-up
E.Divide and conquer
F.Examine SLAs
A.Extranet VPN
B.Managed overlay VPN topology
C.Hub-and-spoke VPN topology
D.Central-site VPN topology
E.Full mesh VPN topology
F.Remote-access VPN topology
A.The interface must be configured as a Multilink PPP interface
B.The correct bandwidth should be configured on the interface
C.A QoS policy must not be currently attached to the interface
D.CEF must be enabled
E.AutoQoS must be enabled globally before it can be enabled on the interface
F.An IP address must be configured on the interface if its speed is equal to or less than 768 kbps
A.Serial connection
B.Secure Shell
C.RADIUS
D.Simple Network Management Protocol
E.HTTP
F.Telnet
A.A BPDU Guard port should only be configured on ports with PortFast enabled
B.BPDU Guard and PortFast should not be enabled on the same port.
C.BPDU Guard is used to ensure that superior BPDUs are not received on a switch port
D.A BPDU Guard port receiving a BPDU will go into err-disable state
E.A BPDU Guard port receiving a BPDU will be disabled
F.BPDU Guard can be enabled on any switch port
A.All traffic is tagged with a specific VLAN ID from the VLAN of the attacker and is now viewable
B.Clients will forward packets to the attacking device, which will in turn send them to the desireddestination but not before recording the traffic patterns
C.All traffic is redirected to the VLAN that the attacker used to flood the CAM table
D.All traffic is flooded out all ports and an attacker is able to capture all data
E.None of the other alternatives apply
A.MAC spoofing
B.VLAN hopping
C.MAC address flooding
D.DHCP flooding
E.Session hijacking
A.Enable BPD guard
B.Disable CDP on ports where it is not necessary
C.Place unused ports in a common unrouted VLAN
D.Prevent automatic trunk configuration
E.Implement port security
最新試題
Drag the DSL technologies on the left to their maximum(down/up) data rate values on the below.
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed?()
As a network engineer, do you know for what purpose SDM uses Security Device Event Exchange(SDEE)?()
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.
Which statement about PPPoA configuration is correct?()
Drag the DSL local loop topic on the left to the correct descriptions on the right.
cisco ios command to interface dialer 0
In computer security, AAA stands for authentication, authorization and accounting. Which optionabout the AAA authentication enable default group radius enable command is correct?()
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.(Not all options will be used)
Drag the IPsec protocol description from the above to the correct protocol type on the below.(Notall descriptions will be used)Drag and Drop question, drag each item to its proper location.