A.Extranet VPN
B.Managed overlay VPN topology
C.Hub-and-spoke VPN topology
D.Central-site VPN topology
E.Full mesh VPN topology
F.Remote-access VPN topology
您可能感興趣的試卷
你可能感興趣的試題
A.The interface must be configured as a Multilink PPP interface
B.The correct bandwidth should be configured on the interface
C.A QoS policy must not be currently attached to the interface
D.CEF must be enabled
E.AutoQoS must be enabled globally before it can be enabled on the interface
F.An IP address must be configured on the interface if its speed is equal to or less than 768 kbps
A.Serial connection
B.Secure Shell
C.RADIUS
D.Simple Network Management Protocol
E.HTTP
F.Telnet
A.A BPDU Guard port should only be configured on ports with PortFast enabled
B.BPDU Guard and PortFast should not be enabled on the same port.
C.BPDU Guard is used to ensure that superior BPDUs are not received on a switch port
D.A BPDU Guard port receiving a BPDU will go into err-disable state
E.A BPDU Guard port receiving a BPDU will be disabled
F.BPDU Guard can be enabled on any switch port
A.All traffic is tagged with a specific VLAN ID from the VLAN of the attacker and is now viewable
B.Clients will forward packets to the attacking device, which will in turn send them to the desireddestination but not before recording the traffic patterns
C.All traffic is redirected to the VLAN that the attacker used to flood the CAM table
D.All traffic is flooded out all ports and an attacker is able to capture all data
E.None of the other alternatives apply
A.MAC spoofing
B.VLAN hopping
C.MAC address flooding
D.DHCP flooding
E.Session hijacking
A.Enable BPD guard
B.Disable CDP on ports where it is not necessary
C.Place unused ports in a common unrouted VLAN
D.Prevent automatic trunk configuration
E.Implement port security
Refer to the exhibit. Based upon the configuration, you need to understand why the policy routingmatch counts are not increasing. Which would be the first logical step to take?Select the bestresponse.()
A.Confirm if there are other problematic route-map statements thatprecede divert
B.Check the access list for log hits
C.Check the routing table for 212.50.185.126
D.Remove any two of the set clauses(Multiple set clause entries will cause PBR to use therouting table.)
Study the following graphic carefully Host1 and Host2, which belong to different VLANs, are in thesame subnet. According to the information displayed, which description is correct when trying toping from host to host?()
A.A trunk port should be configured on the link between CK-SW1 and CK-SW2 to pingsuccessfully
B.The two hosts should be in the same VLAN in order to ping successfully
C.A Layer 3 device is a must in order for the ping command to be successful
D.The ping command will be successful without any further configuration changes
Refer to the exhibit. VLAN2, VLAN3, and VLAN10 are configured on the switch D-SW1.Host computers are on VLAN 2 (10.1.2.0), servers are on VLAN 3 (10.1.3.0), and the
management VLAN is on VLAN10 (10.1.10.0). Hosts are able to ping each other but are unable toreach the servers. On the basis of the exhibited output, which configuration solution could rectifythe problem?()
A.Enable IP routing on the switch D-SW1
B.Configure a default route that points toward network 200.1.1.0/24
C.Assign an IP address of 10.1.3.1/24 to VLAN3
D.Configure default gateways to IP address 10.1.2.1 on each host
E.Configure default gateways to IP address 10.1.10.1 on each host
F.Configure default gateways to IP address 200.1.1.2 on each host
Refer to the exhibit. Host A and Host B are connected to the Catalyst 3550 switch and have beenassigned to their respective VLANs. The rest of the 3550 configuration is the default configuration.Host A is able to ping its default gateway, 10.10.10.1, but is unable to ping Host B. Given theoutput displayed in the exhibit, which statement is true?()
A.HSRP must be configured on SW1
B.A separate router is required to support interVLAN routing
C.Interface VLAN 10 must be configured on the SW1 switch
D.The global config command ip routing must be configured on the SW1 switch
E.VLANs 10 and 15 must be created in the VLAN database mode
F.VTP must be configured to support interVLAN routing
最新試題
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.(Not all options will be used)
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions, you will need to referto the SDM and the topology, neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete?()
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
Refer to the exhibit. Which two statements about the AAA configuration are true?()
Match the xDSL type on the above to the most appropriate implementation on the below.
Study the exhibit carefully. The Cisco IOS IPsec High Availability (IPsec HA) Enhancementsfeature provides an infrastructure for reliable and secure networks to provide transparent availability of the VPN gateways - that is, Cisco IOS Software-based routers. What are the twooptions that are used to provide High Availability IPsec?()
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
Drag and drop question. The upper gives the MPLS functions, the bottom describes the planes.Drag the above items to the proper location at the below
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.(Not allstatements will be used)
Drag each element of the Cisco IOS Firewall Feature Set from the above and drop onto itsdescription on the below.