The network consists of two separate autonomous systems as shown below：
You need to configure Router R2 as a BGP route reflector and Router R1 as the client. Assumingthat Router R3 isn’t running BGP， which two of the commands below would you enter on R2 tosatisfy your goals？（）
A.neighbor 165.50.12.1 remote-as 65100
B.neighbor 165.50.12.2 remote-as 64000
C.neighbor 165.50.12.1 route-reflector-client
D.neighbor 165.50.12.2 route reflector-client
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. All routers are configured for BGP. EBGP routes received on router R2 showup in the BGP table on routers R1 and R3 but not in their IP routing tables. What would causethis？（）
A.EBGP multihop is not configured on routers R1 and R3
B.Routers R1 and R3 do not receive the same routes via an IGP
C.Synchronization in autonomous system 100 is turned is on
D.The BGP routers in autonomous system 100 are not logically fully-meshed
E.Synchronization in autonomous system 100 is turned is off
A.When traffic is sent from the ISP to autonomous system 64512， the traffic will be forwarded toSanJose2 because of the higher MED value of SanJose2
B.The serial 0/0/1 interface on the ISP router has been configured with the set metric 50command
C.The output was generated by entering the show ip bgp command on the SanJose1 router
D.The output was generated by entering the show ip bgp command on the ISP router
E.The serial 0/0/1 interface on the ISP router has been configured with the set metric 75command
F.When traffic is sent from the ISP to autonomous system 64512， the traffic will be forwarded toSanJose1 because of the lower MED value of SanJose1
Refer to the exhibit. Router RT3 discovers network 202.176.56.0 via BGP. Which one of thesestatements is true？（）
A.RT1 advertised network 202.176.50.0/24 with a metric of 782
B.RT3 is directly connected to RT1 using subnet 192.168.1.0
C.RT3 has an IGP metric of 782 to reach 192.168.1.1
D.RT3 has a BGP metric of 782 to reach 192.168.1.1
E.RT1 advertised network 202.176.50.0/24 with a metric of 1000
F.RT3 has an IGP metric of 1782 to reach 202.176.56.0/24
A.Memory requirements are higher for shared distribution tree than for source distributiontree.
B.Creates a tree from a central RP to all last-hoprouters.
C.Uses a rendezvous point.
D.An optimal path is created between each source router and each last-hoprouter.
E.Place（S，G）entry in each router’smulticast routing table.
F.Place（*，G）entry in a router’smulticast routing to table.
Refer to the exhibit. Routers RTA and RTB are running BGP but the session is active. Whatcommand needs to be added to establish the BGP session？（）
A.ip route 10.10.10.1 255.255.255.255 s0/0 ip route 10.10.10.1 255.255.255.255 s0/1
B.network 10.10.10.0
C.no synchronization
D.neighbor 10.10.10.1 next-hop-self
A.Statically defined RP
B.Bootstrap Router
C.Auto-RP
D.RP Discovery Protocol（RDP）
E.RP Helios
F.RPARP（RARP）
A.Clear the BGP session
B.Change both the inbound and outbound policy related to this route
C.Use the service-policy command to adjust the QOS policy to allow the route to propagate
D.Use the release BGP routing command
Refer to the exhibit. Router RTR is attempting to establish BGP neighbor relationships with routersRT1 and RT3. On the basis of the information that is presented in the exhibit， which twostatements are true？（）
A.RTR has a BGP password set but neighbor 10.0.0.1 does not
B.Neighbor 10.0.0.5 has a BGP password set but RTR does not
C.RTR has a BGP password set but neighbor 10.0.0.5 does not
D.RTR has a BGP password set but neighbor 10.0.0.1 has an incorrect password set
E.Neighbor 10.0.0.1 has a BGP password set but RTR does not.
F.RTR has a BGP password set but neighbor 10.0.0.5 has an incorrect password set
A.it is not a valid NetFlow command.
B.it is an SNMP command tha texports1500-byte packets to IPaddress192.168.1.50.
C.it is a NetFlov/command that v/ill export 1500-byte packets to IP address192.168.1.50.
D.it is a NetFlov/command that allows IP address192.168.1.50 to send traffic to port 1500.
E.It is a NetFlov/command that v/ill specify that the NetFlov/collector’s IP address is 192.168.1.50 over UDP port 1500
While verifying BGP operation on the Company router， you issue the "show ip bgp" command asshown below：
From the information above， which path will the network 143.16.0.0 prefer to take to exit the AS？（）
A.128.214.63.2
B.192.208.10.5
C.128.213.63.5
D.203.250.13.41
E.All of the above will be used in a round robin fashion
最新試題
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）
Which statement about PPPoA configuration is correct？（）
Refer to the exhibit. Which two statements about the AAA configuration are true？（）
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Which three statements accurately describe IOS Firewall configurations？（）
Study the exhibit carefully.Routers A and B are customer routers. Routers 1， 2， 3 and 4 are provider routers. The routers areoperating with various IOS versions. Which frame mode MPLS configuration statement is true？（）
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed？（）