A.it is not a valid NetFlow command.
B.it is an SNMP command tha texports1500-byte packets to IPaddress192.168.1.50.
C.it is a NetFlov/command that v/ill export 1500-byte packets to IP address192.168.1.50.
D.it is a NetFlov/command that allows IP address192.168.1.50 to send traffic to port 1500.
E.It is a NetFlov/command that v/ill specify that the NetFlov/collector’s IP address is 192.168.1.50 over UDP port 1500
您可能感興趣的試卷
你可能感興趣的試題
While verifying BGP operation on the Company router， you issue the "show ip bgp" command asshown below：
From the information above， which path will the network 143.16.0.0 prefer to take to exit the AS？（）
A.128.214.63.2
B.192.208.10.5
C.128.213.63.5
D.203.250.13.41
E.All of the above will be used in a round robin fashion
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clickingthe numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible. To gain access to either thetopology or the SDM， click on the button to left side of the screen that corresponds to the sectionyou wish to access. When you have finished viewing the topology the SDM， you can return to yourquestions by clicking on the Questions button to the left.
Off Shore Industries is a large worldwide sailing charter. The company has recently upgraded itsInternet connectivity. As a recent addition to the network engineering team， you have been taskedwith documenting the active Firewall configurations on the Annapolis router using the Cisco Routerand Security Device Manager （SDM） utility. Using the SDM output from Firewall and ACL Tasksunder the Configure tab， answer the following questions：
Which two options would be correct for a permissible incoming TCP packet on an untrustedinterface in this configuration？（）
A.The packet has a source address of 172.16.29.12
B.The packet has a source address of 10.94.61.29
C.The session originated from a trusted interface
D.The application is not specified within the inspection rule SDM_LOW
E.The packet has a source address of 198.133.219.144
A.Following the traffic path
B.Top-down
C.Comparing configurations
D.Bottom-up
E.Divide and conquer
F.ExamineS LAs
Which two of the following descriptions are correct according to the displayed output of thecommand show ip bgp summary？（）
A.The BGP session to the 10.1.1.1 neighbor is established
B.The router is trying to create a BGP peering session with the 10.1.1.1 neighbor
C.The BGP session to the 10.3.3.3 neighbor is created， but the router received no BGP routingupdates from the 10.3.3.3 neighbor
D.The router is attempting to establish a BGP peering session with the 10.2.2.2 neighbor
A.Extranet VPN
B.Managed overlay VPN topology
C.Hub-and-spoke VPN topology
D.Central-site VPN topology
E.Full mesh VPN topology
F.Remote-access VPN topology
A.The interface must be configured as a Multilink PPP interface.
B.The correct bandwidth should be configured on the interface.
C.A QoS policy must not be currently attached to the interface.
D.CEF must be enable
E.AutoQoS must be enabled globally before it can be enabled on the interface.
F.An IP address must be configured on the interface if its speed is equal to or less than 768 kbps.
A.show ip bgp
B.show ip bgp paths
C.show ip bgp peers
D.show ip bgp summary
E.show ip bgp protocols
A problem was reported that the 10.10.10.0/24 prefix was not injected into the local BGP table ona Company router named R1. The following information is available from this router：
R1 Configuration：
router bgp 65001
network 10.0.0.0
neighbor 172.16.1.1 remote-as 65002
no auto-summary
Routing table information：
show ip route | include 10
O 10.10.10.0/24 [110/11] via 192.168.1.1， 2d00h， Ethernet0/0
Why is this prefix not in the local BGP table of the R1？（）
A.The 172.16.1.1 neighbor is down.
B.The prefix 10.10.10.0/24 is not a ’connected’ route
C.This route is not a BGP learned route
D.The network command is wrong
E.None of the other alternatives apply
A.show ospf
B.show ip route
C.show ip protocols
D.show ip ospf database
E.None of the other alternatives apply
Exhibit：
You work as a network technician. You trainee shows you the IOS command output displayed inthe exhibit. What command did Tess use to produce this output？（）
A.show ip RIP
B.show ipv6 ospf
C.show ip ospf
D.show ip ospf interface
E.show ipv6 ospf interface
F.show ipv4 ospf
G.None of the other alternatives apply
最新試題
Which statement about PPPoA configuration is correct？（）
Drag the IPsec protocol description from the above to the correct protocol type on the below.（Notall descriptions will be used）Drag and Drop question， drag each item to its proper location.
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.（Not all options will be used）
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.
As a network technician， do you know what is a recommended practice for secure configurationmanagement？（）
Authentication is the process of determining if a user or identity is who they claim to be. Refer tothe exhibit. Which statement about the authentication process is correct？（）
IPSec VPN is a widely-acknowledged solution for enterprise network. Which three IPsec VPNstatements are true？（）
Study the exhibit carefully. The Cisco IOS IPsec High Availability （IPsec HA） Enhancementsfeature provides an infrastructure for reliable and secure networks to provide transparent availability of the VPN gateways - that is， Cisco IOS Software-based routers. What are the twooptions that are used to provide High Availability IPsec？（）
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）