A.Following the traffic path
B.Top-down
C.Comparing configurations
D.Bottom-up
E.Divide and conquer
F.ExamineS LAs
您可能感興趣的試卷
你可能感興趣的試題
Which two of the following descriptions are correct according to the displayed output of thecommand show ip bgp summary？（）
A.The BGP session to the 10.1.1.1 neighbor is established
B.The router is trying to create a BGP peering session with the 10.1.1.1 neighbor
C.The BGP session to the 10.3.3.3 neighbor is created， but the router received no BGP routingupdates from the 10.3.3.3 neighbor
D.The router is attempting to establish a BGP peering session with the 10.2.2.2 neighbor
A.Extranet VPN
B.Managed overlay VPN topology
C.Hub-and-spoke VPN topology
D.Central-site VPN topology
E.Full mesh VPN topology
F.Remote-access VPN topology
A.The interface must be configured as a Multilink PPP interface.
B.The correct bandwidth should be configured on the interface.
C.A QoS policy must not be currently attached to the interface.
D.CEF must be enable
E.AutoQoS must be enabled globally before it can be enabled on the interface.
F.An IP address must be configured on the interface if its speed is equal to or less than 768 kbps.
A.show ip bgp
B.show ip bgp paths
C.show ip bgp peers
D.show ip bgp summary
E.show ip bgp protocols
A problem was reported that the 10.10.10.0/24 prefix was not injected into the local BGP table ona Company router named R1. The following information is available from this router：
R1 Configuration：
router bgp 65001
network 10.0.0.0
neighbor 172.16.1.1 remote-as 65002
no auto-summary
Routing table information：
show ip route | include 10
O 10.10.10.0/24 [110/11] via 192.168.1.1， 2d00h， Ethernet0/0
Why is this prefix not in the local BGP table of the R1？（）
A.The 172.16.1.1 neighbor is down.
B.The prefix 10.10.10.0/24 is not a ’connected’ route
C.This route is not a BGP learned route
D.The network command is wrong
E.None of the other alternatives apply
A.show ospf
B.show ip route
C.show ip protocols
D.show ip ospf database
E.None of the other alternatives apply
Exhibit：
You work as a network technician. You trainee shows you the IOS command output displayed inthe exhibit. What command did Tess use to produce this output？（）
A.show ip RIP
B.show ipv6 ospf
C.show ip ospf
D.show ip ospf interface
E.show ipv6 ospf interface
F.show ipv4 ospf
G.None of the other alternatives apply
A.Serial connection
B.Secure Shell
C.RADIUS
D.Simple Network Management Protocol
E.HTTP
F.Telnet
A.show ip protocol
B.show ip route
C.show ip ospf interface
D.show ip ospf
E.show ip interface
F.None of the other alternatives apply
A.ABPDU Guard port should only be configured on ports with PortFast enabled.
B.BPDU Guard and PortFast should not be enabled on the same port.
C.BPDU Guard is used to ensure that superior BPDUs are not received on a switch port.
D.ABPDU Guard port receiving a BPDU will go into err-disablestate.
E.ABPDU Guard port receiving a BPDU will be disabled.
F.BPDU Guard can be enabled on any switch port.
最新試題
Drag the DSL technologies on the left to their maximum（down/up） data rate values on the below.
As a network technician， do you know what is a recommended practice for secure configurationmanagement？（）
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete？（）
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.（Not all options will be used）
Drag each element of the Cisco IOS Firewall Feature Set from the above and drop onto itsdescription on the below.
Drag the DSL local loop topic on the left to the correct descriptions on the right.
Which statement correctly describes IPsec VPN backup technology？（）
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）